Xenon lamp aging test chamber xenon lamp replacement precautions

To understand what the equipment is used for, the composition of each accessory and system of the xenon lamp weathering tester will reflect different functions
.

Each component of the xenon lamp aging test chamber cannot be without a xenon lamp part
in the equipment.

The entire test is operated because the xenon lamp will operate normally in the device, reacting more strongly in the corresponding environmental conditions and acceleration tests
.

When replacing the xenon lamp in the xenon lamp aging test chamber, pay attention to the fact that the quartz should maintain its cleanliness in the bubble shell and there must be no dirt
.

Of course, before use, it needs to be wiped clean with an alcohol cotton pad before it can be lit; Xenon lamps are filled with high-pressure gases
.

Care should be taken to avoid collisions during loading and unloading and transportation, as it is at the time
of single installation.

Of course, when working, it should be placed inside the cover with good heat dissipation to prevent explosions and strong light, strong ultraviolet rays will burn the skin and eyes; Due to the large current, the lamp holder has good contact with the lamp holder, and the contact point must be cleaned during use; In addition, xenon lamps must be used
with *dc power supplies and flip-flops.

The ripple coefficient of the DC power supply shall not be greater than 7%, and the working current during ignition should be within the specified range, otherwise it will affect the service life
of the lamp.

When replacing xenon lamps, they are handled
one by one according to the above precautions.

Based on the analysis and test status of each step in the xenon lamp aging test chamber, a more accurate and stable state
can be presented than expected.