-
Categories
-
Pharmaceutical Intermediates
-
Active Pharmaceutical Ingredients
-
Food Additives
- Industrial Coatings
- Agrochemicals
- Dyes and Pigments
- Surfactant
- Flavors and Fragrances
- Chemical Reagents
- Catalyst and Auxiliary
- Natural Products
- Inorganic Chemistry
-
Organic Chemistry
-
Biochemical Engineering
- Analytical Chemistry
-
Cosmetic Ingredient
- Water Treatment Chemical
-
Pharmaceutical Intermediates
Promotion
ECHEMI Mall
Wholesale
Weekly Price
Exhibition
News
-
Trade Service
Pharmaceutical Network Technical Article: The wind shower room is a kind of local purification equipment with strong generality, which is installed between the clean room and the non-clean room It can effectively blow off the human body or carry the surface of the surface of the dust, blowing dust with the circulating air flow again through the primary effect filter, so return, in order to achieve the purpose of wind
In pharmaceutical and other workshops, the use of wind shower room is widely used When workers enter the workshop, they need to use the device and use strong clean air, rotating nozzles from all directions to the body, effectively and quickly remove dust, hair, hair and other debris attached to clothing, reducing the pollution caused by people entering and leaving the clean room With the improvement of cleanliness requirements in the pharmaceutical and other industries, the issue of human pollution sources has been paid more attention, and the role of the wind shower chamber is becoming more and more important
However, in use, the wind shower room often appear some common failures, need operators to understand and master the reasons and solutions, in order to prevent the failure to occur helpless, delay production
Fault one, the fan in the shower room does not work For the wind shower room does not work, the operator should check in time the wind outdoor box emergency switch is cut off, such as to determine cut off, hand gently press, to the right side of the rotation can let the fan resume work
Fault two, the wind shower room fan reverse or the wind speed of the wind shower room is very small In this case, need to check whether the line is reversed, the general wind shower room manufacturer factory installation will have a special electrician to pick up the line, if confirmed is back to the wind shower room line source, light will cause the wind shower room fan does not work or reverse the wind speed of the shower room reduced, heavy will burn the entire air shower room line board
Industry advice, the use of wind shower room enterprises do not lightly to change wiring, because the production needs to determine to move, you can consult the wind shower room manufacturers to solve
Fault three, the wind room does not blow In addition to the above, the wind shower room may also occur without blowing phenomenon This situation needs to check whether the emergency stop key inside the box of the wind shower chamber is pressed, such as the emergency stop key is color,, the wind shower room will not blow You need to press the emergency stop key again to get back to normal work
Fault four, the wind shower room can not automatically sense the blow It is necessary to check the light sense system in the lower right corner of the air-soaked indoor box to see if the light-sensitive device is installed correctly, such as the light sense of the two sides are opposite and the light sense is normal, can automatically sense the blow
Fault five, the wind room after a period of use, the wind speed becomes very low Industry advice, check the first and early filters of the air shower chamber whether there is too much dust, such as dust problems can be replaced filters
It also reminds the user that the maintenance of the shower room is of paramount importance In the case of the primary effect filter of the wind shower chamber, it is usually replaced once in 1-6 months, and the filter of the shower chamber is normally replaced once in 6-12 months Ensure that the filter is normal in order to ensure the stable operation of the device
Of course, when the user buys the shower room, the filter, control circuit and other quality problems should be taken into account It is understood that the market is usually introduced without partition filter, there are partition filters already belong to the relatively early wind shower room matching In addition, a good wind shower room control circuit is usually integrated control system, is the wind shower room dedicated control circuit, there is an emergency stop, manual start, wind shower time conditioning and other modules.