Why do your titanium rod filter elements change so often?

Titanium rod filter is widely used in water production and other fields, if the titanium rod filter element replacement frequency is high, it is generally caused
by the following factors.

1.
The quality of raw water is unstable and fluctuates frequently, resulting in too much
particulate matter entering the filter element.

2.
Poor
pretreatment effect.

The flocculant and scale inhibitor added to the pretreatment are incompatible with each other or do not match
the water source.

The viscous material formed adheres to the surface of the filter element, resulting in a reduction in the filter area and frequent
replacement of the filter element.

3.
Poor
quality of the filter element.

The inner and outer pore diameters of the poor quality filter elements are basically the same
.

In fact, only the outer layer plays the role of interception, and the filter pore size of a good filter element is gradually reduced from the outside in
.

The inner layer filtration accuracy is 5±0.
5μm, and the amount of dirt is getting larger and larger
.

After a long time, the quality of the effluent can be guaranteed
.

Good titanium rod filter element performance is stable, impact resistance, resistance to alternating loads is better than other metal filter materials
.

Good breathability, stable
separation effect.

Excellent mechanical strength for high temperature, high pressure and strong corrosive environments
.

Particularly suitable for high temperature gas filtration
.

When selecting titanium rod filter element, the following points should be noted: 1.
The chemical properties
of the filter material.

2.
Physical properties
of the filter material.

Titanium rod filter element has a good effect
on filtering rigid solid particles.

3.
Suitable titanium rod filter element accuracy
.

The pore size of the selected titanium rod filter element should be much smaller than the diameter of the solid impurities, so as to avoid solid impurities from entering the channel
within the wall of the titanium rod filter element.

4.
The pressure
used in the titanium rod filter element.

Generally, it should be controlled within 0.
3MPa, otherwise it will increase the difficulty of
regeneration.

5.
Suitable titanium rod filter element regeneration method
.

Choose different regeneration methods for different impurities, including backflushing, backwashing, water washing, pickling, alkali washing, ultrasonic cleaning, etc
.