What to be aware of when using a single stamping chip.

Single stamping chip machine belongs to a small mechanical equipment in the process of use in order to avoid some damage caused by the work is not complete or even cause serious factors of production so we need to pay attention to some related mattersWhen using a single stamping chip machine need stake in the following things: electric press should be the handwheel on the turning handle to avoid running to avoid injury, the machine can only be operated in a certain direction see the handwheel or the arrow on the shield showed not reversible to avoid damage to the machine partsIn particular, care should be taken not to neglect when adjusting the tablet, whether the manual or electric press should place the upper core lever in the rising position before startingIf the upper punch in the case of the drop position startis on the start of the into the medium mold plate at this time because the machine speed has not risen up inertia less prone to the top car situationThat is, the upper punch into the middle mold, due to the resistance of the tablets and "top death" so that the machine stopped runningWhen the top car due to the heavy load often damage the machine analysis or burn the motorWhen there is no power supply, the triangular belt should be removed to reduce resistance and wearBut don't remove the large pulley sesame because the large pulley has the function of flywheel labor savingBefore first use, read the instructions carefully before using the machine in kind and then use themBelt loosening adjustment: adjusted by two adjustment nuts on the electromechanical base platePay attention to locking after adjustment