What details need to be paid attention to in the reactor nitric acid cooling system

Many users buy a reactor nitric acid cooling system, often do not notice what details
need to be paid attention to when the equipment is started.

Need to check whether there are fewer pieces of goods, there is loss, whether it can be used normally is the same, so the following Xiaobian will explain to you what details
you need to pay attention to when booting.

The operating principle of the reactor nitric acid cooling system is to convert electrical energy into thermal energy to heat the material to be heated
.

In the work, the low temperature fluid medium enters its input port through the pipeline under pressure, along the specific heat exchange channel inside the electric heating vessel, and uses the path designed by the principle of fluid thermodynamics to take away the high temperature heat energy generated in the work of the electric heating element, so that the temperature of the heated medium is increased, and the electric heater outlet obtains the high temperature medium
required by the process.

1.
Check whether the packaging is damaged and whether the anti-upside down label on the packaging box is normal; Count the types and quantities
by the contents of the Packing List.

2.
When disassembling the package, please pay attention not to touch the test box, and also need to remove the pad at
the bottom of the compressor.

3.
The reaction kettle nitric acid cooling system is placed in a position to adjust the level, and at least reserve a certain distance of maintenance space
.

4.
Open the electrical control cabinet to check whether the terminals of the components are loose; Whether the water tank of the waterway is damaged, whether the fixing screw is loose, and the power line and grounding wire are connected after checking it correctly
.

5, in the reactor nitric acid cooling system drain joint connected to the water pipe, the length of a single water pipe can not exceed 1 meter, and the outlet of the water pipe into the floor drain, if there is no floor drain, you can directly place the water box
under the joint.

6, the reactor nitric acid cooling system heat pipe heat dissipation, if at the time of high-speed operation, suddenly there is no water fluidity, a lot of heat can not be immediately evaporated, resulting in a very fast
rate of temperature rise.

When the temperature exceeds the zero point of high temperature, the device will maintain itself
according to the shutdown method.

The above points are the details that Xiaobian told for everyone, about the details that need to be paid attention to when the reactor nitric acid cooling system is started
.