What details are needed when the small heat and cold machine is turned on

After many users buy a small cooling and heating all-in-one machine, they often do not notice the details that need to be paid attention to when the device is turned on
.

It is necessary to check whether there are few pieces of the product, there is loss, and whether it can be used normally is the same, so the following editor will explain to you what details you need to pay attention to when starting the small hot and cold all-in-one machine
.


1.
Check whether the packaging is damaged and whether the anti-fall mark on the packaging box is normal; check the type and quantity according to the contents in the "Packing List"; 2.
Please be careful not to damage the test box when unpacking, and also need to remove the compressor 3.
Adjust the level after the small cooling and heating integrated machine is placed in the position, and reserve at least a certain distance for the maintenance space of the test box; 4.
Open the electrical control cabinet to check whether the components have loose terminals; the water box of the waterway Whether there is damage, whether the fixing screws are loose, connect the power line and grounding line after checking; 5.
Connect a water pipe to the drain joint of the small heat and cold integrated machine.
The length of a single water pipe cannot exceed 1 meter, and the The outlet of the water pipe extends into the floor drain.
If there is no floor drain, the water box can be placed directly under the joint; 6.
The heat pipe of the small cooling and heating integrated machine dissipates heat.
If it is running at high speed, there is suddenly no fluidity of water and a lot of heat Evaporation cannot be carried out immediately, resulting in a very rapid rate of temperature increase
.

When the temperature exceeds the high temperature zero point, the small cooling and heating unit will maintain itself according to the shutdown method
.

The above points are what the editor told you about the details that need to be paid attention to when the small hot and cold integrated machine is turned on.
After all the above checks are normal, the small hot and cold integrated machine can be run.
I hope it can help you better.
to use this product
.