What are the precautions for the use of ultrasonic cleaners?

What are the precautions for the use of ultrasonic cleaners? Ultrasonic cleaning machine is a kind of equipment that uses ultrasonic waves for cleaning operations.
It has the advantages of good cleaning effect, simple operation and flexible use
.

So, what should be paid attention to when using an ultrasonic cleaner? Here's a detailed introduction to the 5 major use points of ultrasonic cleaning machines, hoping to help everyone
.

1.
Installation of ultrasonic cleaner
.

Please refer to the installation manual of the ultrasonic cleaning machine to connect the temperature control sensor signal line, ultrasonic drive line, heater control line and other lines between the electric control cabinet of the cleaning machine and the host, and connect the 380VAC power supply, and install the water supply pipe and water discharge pipe of the cleaning machine.
with overflow drain
.

2.
Add water to the ultrasonic cleaner
.

 　　Add an appropriate amount of clean water to the cleaning pool, and the height of the liquid level is subject to immersion of the parts to be cleaned, generally not more than three-quarters of the cleaning pool
.

 　　3.
Ultrasonic cleaning machine heating
.

 　　Start the electric control heating switch, and point the white scale line on the water temperature adjustment knob to the appropriate temperature (should be about 60°C)
.

During the use of the cleaning machine, the high temperature of the cleaning machine should not exceed 70 °C
.

 　　4.
Add cleaning agent to ultrasonic cleaner
.

 　　When the water temperature rises to about 40°C, add the parts cleaning agent into the cleaning tank (usually about 5kg at a time), and slowly stir the water to fully dissolve it (you can also start the supersonic wave or open the air blowing device for stirring)
.

 　　5.
Ultrasonic cleaning machine pretreatment
.

 　　Before cleaning, it is advisable to use a bamboo knife to clean the dirt on the surface of the parts (for example, there will be a lot of dust on the outer surface of the dust cover, and the parts of the cylinder block will accumulate a lot of thick and easy-to-remove sludge where the curve of the casing changes) simply clean.
to extend the life of the cleaning fluid
.

 　　The above is the relevant introduction about the use of ultrasonic cleaning machine.
Ultrasonic can perform precise cleaning, but its ability to treat mud-like dirt is weak.
Therefore, in pretreatment, yellow mud or thin mud-like dirt should be removed as much as possible.
Hope Can help everyone
.