What are the precautions for maintaining the labeling machine?

What are the precautions for maintaining the labeling machine? Shanghai Lujia Automation Technology Co.
, Ltd.
is located in the modern high-tech park in the center of Jinhui Town, Fengxian District
.

Committed to the research and development and production of packaging automation equipment, application industries: pharmaceutical, food, cosmetics, daily chemicals, electronics, chemical industry, automotive industry, plastics and hardware and other major industries! Labeling machine precautions: 1.
Don't underestimate labeling The cleaning of the machine is not something that can be solved by simply brushing and washing.
There are many precautions that need to be paid attention to
.

For example, high pressure and hot water jetting devices cannot be used to clean the labeling machine; electrical and electronic components must always be kept dry; high alkali and high acid cleaning agents cannot be used to clean equipment; when cleaning equipment, the temperature of water is generally 30~40 ° C
.

2.
In addition, such as Zhuanyi, Zhuanyi sponge, Zhuanyi clip fingers, pads, target plates and target plate jackets, rubber rollers, scrapers, standard boxes, etc.
can be brushed with a damp cloth, and the surface of the equipment can be cleaned with a damp cloth.
Wet cloth can also be used to clean, you can also use a brush, dry cloth,
etc.

There are many points to pay attention to when cleaning these parts.
For example, when cleaning the target plate and the target plate jacket, the target plate and the target plate shaft should be cleaned in a warm water pool.
After cleaning, dry it and use compressed air if necessary.
Blow dry
.

When installing the shaft end of the target plate, apply a little lubricating oil to facilitate installation and disassembly
.

It should be noted that the target board must be placed upright or parallel
.

  3.
For example, when cleaning the surface of the equipment, use a brush to remove broken glass and broken label paper on the surface of the equipment, wipe the glue thrown off the table with a damp cloth, and wipe the protective cover with a dry cloth
.

The operator needs to pay attention not to use sharp instruments to remove the residual glue.
You can add lubricating oil to the rollers and shafts of the drum every day, and remember to clean the oil nozzle before refueling
.

Only when the equipment is cleaned properly can the service life of the equipment be extended and thus run better
.