The stirring system vibrator uses compressed air as a power source

The main purpose of the mixing system is to turn the compacted material into a loose state through low-speed stirring to facilitate the next step of conveying and packaging
.
During work, the mixing shaft set vertically in the mixing silo is rotated by the electric motor, and the mixing blades are installed on the shaft, and the shaft drives the pulp blades to shake the contents of the silo to shear.
Forced stirring action
for squeezing and flipping.
The material is stirred and loosened
in relative motion.
Detailed explanation of the composition of the mixing system: 1.
The main motor should be connected to the two-stage gear reduction box through the belt, and then drive the two horizontally assembled mixing shafts to rotate
at constant speed through two pairs of open gears.
In order to ensure that the gears in the gearbox can work normally, lubricating oil and summer gear oil
must be injected according to the oil level shown in the gearbox.
In the 150th and 300th hours of the new machine, the oil should be changed once in the two periods, and then replaced every 1000 hours of operation
.
2.
The connection between the mixing shaft and the mixing drum is equipped with a special sealing device
.
In order to ensure the sealing quality, a special oil supply is equipped, and the oil supply should be fixed on
the end face of the mixing drum.
When injecting grease into the oil supply, pay attention to cleaning and cleaning, do not mix with debris, should often unscrew the silt plug on the shaft end support seat and find mortar debris, indicating that the first sealing device has lost its function, emergency adjustment and replacement of the first sealing device to ensure the normal operation of the mixing shaft should often inject yellow grease
into the bearing.
3.
The arc part and end face of the mixing drum are welded with
copper plates.
The mixing drum is equipped with 6 kinds of liners, including 84 pieces of 3 types of arc liners and 20 pieces
of 3 types of end face liners.
4.
The mixing drum is equipped with two horizontally configured mixing shafts, each shaft is equipped with seven shovel blades F and side blades are installed on the two shovel arms close to the mixing drum, which can scrape the concrete
on the end face.
The cone section of the mixing system (near the outlet) is also equipped with a vibrator
.
The vibrator uses compressed air as a power source, and the impact force generated is transmitted to the bin wall, so that the material can flow
smoothly.