The purpose of adding water at each location of the salt spray test chamber

Programmable salt spray test box, sprayer is inevitable water, humidifier heating can not avoid water, sealing is the choice of water sealing.
.
.
Now that the application of programmable salt spray test chamber in the whole process of inevitable water, then, the box body has a total of two must release water, what is the purpose of adding water, and what are the common problems in the whole process of water release? Liuqin Technology explains to you one by one: water release system software, existing everywhere need to release water
.
First of all: small box inside the water, the use of water is to heat the shell, the water level only needs to be slightly lower in the middle of the shell of the fog hole can be, if the water is put more, it will be fully automatically discharged
from the water pipe behind the shell.
Secondly: salt water, the role of brine is to impregnate commodities, the proportion of salt water is 1:19 per kilogram of industrial salt with nineteen kilograms of mineral water, the water level as long as it is added to 3/4 of the salt storage tank can be used for two days (Note: the salt storage tank is at the upper end of the operation panel).

Rear: saturation state barrel water release, the effect is to heat the water from the air compressor into the saturation state inside the barrel, humidifier
.
(Note: The saturated state barrel outlet is behind the salt water outlet, and the inlet valve is opened before the saturation state bucket is released, and the water must be turned off after the purchase is completed
).
Rear: water sealing, efficacy: avoid corrosion resistance leakage
.
Saturation state barrel (6-8 liters) 48 hours, 3 days up and down
.
The shell (can add 25 liters per time) 72-100 hours about seven days up and down
.