The main component of the flip type oscillator

1, speed adjustment system: the speed adjustment of the equipment is by the AC asynchronous motor, the use of frequency conversion speed regulation to achieve, frequency conversion speed
regulation.

It has the following characteristics: no carbon brush sliding link, low noise, no spark, small radiation to the power grid, keep the power grid clean, and conducive to environmental protection
.

Reactive power loss is small and energy saving
.

Stable and reliable operation, long
service life.

2, temperature control system: the selection of measurement, conversion integrated temperature sensor, its characteristics: accurate measurement, no debugging, good
linearity of the measurement range.

Due to the use of microprocessor, proportional wide-ranging heating principle, to achieve high temperature control accuracy, good uniformity, reliable
stability.

3, the movement: the movement is an important core part, the use of high-strength structural design, the use of high-precision processing means, reasonable aging treatment and heat treatment to achieve structural strength and stability, in order to ensure the service life
of the machine.

The following Xiaobian to share with you is the temperature setting and opening method of the flip oscillator: 1, open the power switch, set the constant temperature temperature: The control switch is placed in the "setting" section, at this time the temperature displayed on the display is the set temperature, adjust the knob, set to the temperature you need for work
.

The small switch of the control part is placed on the "measurement" end, and the temperature displayed on the display is the actual temperature of the air in the test chamber, and the number displayed will change accordingly as the temperature in the box changes
.

When heated to your desired temperature, the heating will automatically stop and the green indicator light will light up; When the heat in the device is dissipated and lower than the temperature you set, a new round of heating will begin
.

2.
Open the oscillation device: Open the oscillation switch on the control panel, and the indicator light is on
.

Adjust the oscillation speed knob to the desired oscillation frequency
.