Several points that should be paid attention to when operating the snowflake ice maker

The snowflake ice maker produces irregular tiny granular ice slag in the shape of snowflakes, which is widely used in the food industry, such as pre-cooling in the processing of meat foods, moon cakes, bread cakes, and slaughtering
.

The ice shape of the ice maker is a relatively humid, the water content is generally between 15% and 25%, the temperature is slightly lower than zero, the plasticity is good, it is easy to take and accumulate, and the ice shape is small amorphous particles.
The snowflake-shaped crushed ice can penetrate into a narrow gap, the cooling speed is fast, and the ice bath effect is good
.

Notes on Snowflake Ice Machine: 1.
The ice machine should be installed in a place far away from the heat source, without direct sunlight, and in a well-ventilated place.
The ambient temperature should not exceed 35°C, in order to prevent the condenser from being badly dissipated due to excessive ambient temperature.
Ice making effect
.

The ground on which the ice maker is installed should be solid and level, and the ice maker must be kept level, otherwise the ice maker will not be removed and noise will be generated during operation
.

2.
The gap between the back and the left and right sides of the ice maker is not less than 30cm, and the top gap is not less than 60cm
.

3.
The ice maker should use an independent power supply, a dedicated line power supply and be equipped with fuses and leakage protection switches, and must be reliably grounded
.

　　　　4.
The water used by the ice maker should meet the national drinking water standards, and a water filter device should be installed to filter impurities in the water, so as not to block the water pipe and pollute the water tank and ice film
.

And affect the ice making performance
.

　　　　5.
Turn off the power supply when cleaning the Snowflake Ice Machine.
It is strictly forbidden to use the water pipe to flush the machine directly.
Use neutral detergent to scrub, and it is strictly forbidden to use acidic, alkaline and other corrosive solvents for cleaning
.

　　　　6.
The ice maker needs to unscrew the head of the water inlet hose for two months, and clean the filter screen of the water inlet valve to prevent the sand and mud impurities in the water from blocking the water inlet, which will cause the water inlet to become smaller, resulting in no ice making
.

　　　　7.
The ice maker must clean the dust on the surface of the condenser every two months.
Poor condensation and heat dissipation will cause damage to the compressor components
.

When cleaning, use a vacuum cleaner, a small brush, etc.
to clean the oil and dust on the condensing surface.
Do not use sharp metal tools to clean it, so as not to damage the condenser
.

　　　　8.
The water pipes, sinks, storage bins and protective films of the ice maker should be cleaned every two months
.

　　　　9.
When the snow ice machine is not in use, it should be cleaned, and the ice film and the moisture in the box should be dried with a hair dryer, and it should be placed in a non-corrosive gas and ventilated and dry place to avoid storage in the open air
.