Salt spray test chamber after-sales service introduction internal and external structure composition

Introduction of salt spray test chamber after-sales service internal and external structure composition Salt spray test chamber structure: 1.
Sprayer controller: adjust the size of the sprayer, increase the amount of sprayer, reduce the amount of sprayer
.
Salt water heating tank, located at the bottom of the spray tower, the salt water of this tank is introduced into the heating tank through the salt water filling bottle, the water level of the heating tank is operated by the float, which can automatically control the water level line of the system, and the bottom end of the tank has a water outlet for cleaning by the silicone plug manipulation
.
2.
Sprayer tower: The built-in laminated glass nozzle is placed inside the nozzle, and the sprayer is dispersed to the inside of the experiment through the tower pipe guide channel and then through the
conical disperser.
3.
Heating stainless steel sink: This stainless steel sink is attached to the bottom of the laboratory, which is used to hold water to maintain the stability of the laboratory temperature, and its role is to heat, moisturize and replenish water
.
4.
Dust collector: The amount of mist sprayed by the nozzle is placed in an 80CM tube cup by free fall, and then flows from the channel pipe to the
measurement and verification cup.
5.
Dry bulb temperature cup: L-shaped dry bulb temperature cup is a vessel for applying ambient humidity clothing water
.
6.
Storage shelf: This shelf is made of plastic steel profiles, so the net weight of the steel parts is not more than 2Kg, and if it is dispersed, it can bear within
10Kg.
There are two rows of round holes on both sides of the storage shelf, which are used
to put the storage rod at an angle of 15 degrees and 30 degrees in the vertical side.
7.
Filtration device: used to worry about the quality of salt water, laminated glass filter device or plastic filter device
.