Propeller blade dryer KJG-200

Propeller blade dryer KJG-200 blade type dryer is a hollow screw blade set on a hollow shaft, in which the heat carrier is passed, and the material to be dried is fully heat exchanged during stirring for drying, and the role of the screw hollow blade Continue to move forward
.

After the dryer dries the powdery material, and the outer wall of the spiral hollow blade adheres to a little powdery material, then manual cleaning is required, which makes the manual work burden larger.
When drying, only the same direction is turned over, which makes the material reverse unevenly, and affects the drying quality of the material, thereby reducing the practicability of the dryer
.

The hollow paddle horizontal dryer solves the technical problems of inconvenient cleaning of residual powder materials inside the dryer and poor drying quality in the prior art
.

The hollow paddle horizontal dryer includes a drying frame, the bottom end of the drying frame is welded with a support frame, the bottom end of the inner wall of the drying frame is provided with a lifting plate, and the bottom end of the lifting plate is installed with two groups of supporting frames.
Frame-fixed hydraulic cylinder, the inside of the lift plate is provided with two sets of two sets of turning plates extending to the outside of the lift plate, the inside of the lift plate is provided with limit posts that extend to the inside of the turn plate, and the inside of the lift plate There is a clamping column extending to the inside of one end of the turning plate, the bottom end of the turning plate is provided with a brush extending to the outside of the lifting plate, the inside of the drying frame is provided with a No.
1 propeller blade, and a No.
1 propeller blade The side is provided with a No.
2 propeller blade, a motor is installed on one side of the drying frame, the output end of the motor is connected with a rotating column, the outer wall of the rotating column is sleeved with a driving gear, and one end of the No.
2 propeller blade is A driven gear that is engaged with the driving gear is sleeved on the outer wall extending to the drying frame
.

By adopting the above technical solution, the materials inside the drying frame are stirred in two directions relative to each other, and the powder materials are fully dried.
At the same time, the powder materials adhered to the inside of the equipment can be removed, avoiding manual cleaning
.

A matching slot is provided at the contact position of the drying frame and the lifting plate
.

 By adopting the above technical solution, it is convenient to seal the bottom end of the drying frame and avoid the phenomenon of leaking powder materials
.

The output end of the motor is connected with the rotating column through a coupling, and the motor is electrically connected with an external power supply through a wire
.

By adopting the above technical scheme, it is convenient for the motor to better drive the rotation of the rotating column, and then the drying quality of the powder material is improved
.

The contact positions of the No.
1 propeller blade and the No.
2 propeller blade and the drying frame are rotatably connected by bearings
.

By adopting the above technical solutions, the friction between each other is reduced, and the generation of noise is avoided at the same time
.