Problems that should be paid attention to in the cleaning and maintenance of electromagnetic induction sealing machine

Electromagnetic induction sealing machine is a portable electromagnetic induction heating sealing equipment, the machine is small and lightweight, simple to use, short bonding time, fast speed, good sealing, stable performance, can be widely used in pharmaceutical, chemical, pesticide, food, cosmetics, light industry and other small batch production and laboratory operations
.
Electromagnetic induction sealing machine cleaning and maintenance: 1.
Under the condition of turning off the power and restoring normal temperature, regularly clean the surface of the plastic bag sealing machine, the bottom plate and the lower mold sliding plate, groove, the upper mold inner pressure plate and the positioning rod
.
2.
Butter is added regularly to the lower die skateboard, pressure rod bearing, eccentric wheel and guide column, guide rail and other transmission parts to ensure the performance
of the machine.
3
.
When cleaning the tooth knife, plug the two drainage holes of the lower mold with cotton, pour boiling water into the groove of the lower mold, until it is full, press the upper mold down, press it to the low point of zui, and repeat it several times.
4.
Turn off the power in time after use, and clean up the dirty things
on the surface operation plate and sealing and cutting wire of the plastic bag sealing machine in time.
Questions that should be paid attention to in the protection of electromagnetic induction sealing machine: 1.
The electromagnetic induction aluminum foil sealing machine should be placed in a ventilated and boring place, and the general room temperature can be
maintained at about 25 °C.
2.
Every 48 hours of work, 6# oil should be filled with each moving part, mainly in gears, bearings and gearboxes
.
3.
Dust should be removed regularly and the whole machine should be cleaned
.
Unplug the power supply when not in use and cover
it with a cloth.
4.
If the working time is too long, the cooling fan should be turned on before shutting down, and then shut down after the temperature is reduced, because it is not cooled down, the high temperature band is very simple to damage
.
5.
The high temperature belt should be regularly dusted and scaled to ensure the quality of
sealing.
6.
Severely worn parts should be replaced in time to extend the life of
the whole machine.