Precautions for correct operation of capping machine

The capping machine tightens the bottles after vacuumizing, so as to prolong the storage time of the packages, reduce the failure rate of the capping machine and improve the packaging efficiency of the capping machine Attention shall be paid during operation: 1 Adjustment of screw roller: put the bottle on the bracket, raise the bracket to Zui high point, first loosen the lock nut to adjust the screw roller, so that the edge of the two screw rollers (with spring) is on the starting point of the bottle, then loosen the lock nut, and then adjust the adjusting screw to make the edge of the two screw rollers contact with the cover, if there is a little pressure, then lock the nut 2 Adjustment of locking wheel: adjust the two locking wheels, loosen the lock nut first, adjust the locking wheel, make the edge of the two locking wheels contact with the lower edge of the bottle cap, if there is a little pressure, then lock the nut (Note: the adjustment should be loose to tight, and adjust by pulling the lock head) 3, bottle cap lock: loose the top screw, remove the pressure head, then remove the whole lock, install the appropriate plastic lock on the cone sleeve, then adjust the lifting height of the bracket to meet the work requirements 4, height adjustment: start the machine to lower the bracket to the Zui low point, then put the bottle on the bracket, release the brake nut, pull the adjusting screw to make the bracket rise, then adjust the appropriate distance between the bottle cap and the pressure head The capping machine is also called capping machine, capping machine or locking machine, which is used for the tightening and loosening equipment of plastic bottles and glass bottles (molded bottles or tube bottles) after sub loading Capping machine is a kind of intelligent capping equipment with advanced technology, unique design and simple operation During the whole capping process, workers only need to place the cap at the mouth of the bottle, and then the bottle is automatically sent to the capping wheel and automatically tightened to complete the capping operation.