Please adjust the purified water equipment first and then use

Purified water equipment needs to be adjusted before use, and then used, only by setting the purified water equipment to a certain state, can it be better used
.

Do you know how to adjust? The following is a detailed introduction for everyone: 1, the purified water equipment needs to be in place and fixed
according to the requirements of the floor plan.

This water treatment cup installs all the membrane components, valves and pipes
that are removed for transport.

2.
Before the installation of purified water equipment, it is necessary to check whether the connection between all pipelines of purified water equipment is perfect, whether the pressure gauge is complete, and whether the low-pressure pipeline connection is tight, and there is a shortage
.

3.
Start the high-pressure pump at the inlet pressure of the high-pressure pump, open the flushing switch at the same time, start the flushing solenoid valve, control the pressure, and check whether the high and low pressure pipelines and instruments are working properly
.

4.
It is necessary to check the inlet water pipeline, drainage system and concentrated water drainage system of the equipment to ensure that all the hoses are connected to the
link.

Inlet water pressure, production water flow and other parameters
.

The commissioning of purified water equipment is very important, if it is not well debugged, there will be problems in the operation of purified water equipment, and may even lead to unqualified effluent quality and cause great losses
.