Overview of the hot air antivirus box structure

GRX series dry baker is a series of products, the volume is 30, 50, 140, 240 liters four specifications
.

The shell body is painted with steel plate surface, the studio is made of stainless steel plate, and the interior is equipped with a shelf made of two layers of stainless steel wire, and the middle layer is filled with fine glass wool for heat insulation
.

The door is made of double-layer tempered glass doors, which can clearly observe the heated items
in the box.

A heat-resistant silicone rubber seal is installed at the connection between the studio and the door to ensure a seal
between the studio and the door.

Power switches, power indicators, damper adjustment knobs, temperature controllers and other operating parts are concentrated in the control panel in front of the box, set on the left front side
of the box.

The in-box heating constant temperature system is mainly composed
of an electric motor equipped with a centrifugal impeller, an electric heater, a suitable air duct structure and a temperature controller.

When the power is connected, the motor runs at the same time, directly discharging the heat generated by the electric heater located at the rear of the box through the air duct, passing through the dry items in the work room and then sucking in the fan, so as to continuously circulate, so that the temperature in the work room is uniform
.

Intelligent temperature controller, with automatic wind speed adjustment function, in the heating process, the motor runs at high speed, when the temperature is close to constant, it is automatically adjusted to run at low speed, thereby reducing the use of problems
caused by excessive wind speed.

Users can also cancel this feature
with a simple operation.

The damper regulator regulates the amount of
air entering and exiting the box by opening the damper adjustment knob.