Operation method of automatic powder filling machine

The powder filling and capping machine is a special injection powder filling and capping integrated machine developed by our company.
Touch screen PLC control, high filling precision and convenient adjustment
.

This machine can be produced as a single machine, or it can be combined with other equipment to form a linkage production line
.

The powder filling and capping machine is completely manufactured in accordance with GMP standards, and is widely used in pharmaceutical, food, health care products and chemical industries
.

1.
The filling method of the filling machine can be selected in two ways: manual and automatic; when the machine is in use, the vibration (stirring) mode of the operation interface must be turned on for both manual and automatic methods, which can prevent the machine from running.
When unloading, the material in the barrel forms a cavity, resulting in uneven weight
.

2.
The time setting of the vibration (stirring) mode is determined according to the actual feeding time
.

For example: it takes 3 seconds to fill 450 grams of material, and it takes 3 seconds to discharge the material from the feeding port to the inside of the packaging bag; then the preset time of the vibration (stirring) mode is 3.
5 seconds
.

When filling other weights, the preset time is 0.
5 seconds longer than the unloading time
.

 　　3.
If the machine is set to automatic filling mode, the automatic delay time of the operation interface refers to the interval between unloading and the second unloading; the automatic delay time should be greater than each bagging, unloading and the second unloading.
time to bag
.

 　　4.
Setting of filling weight: the weight of filling is obtained by adjusting the number of turns; the number of turns is proportional to the weight of the material; for example: when filling 450 grams of powder, the number of turns is displayed as 05.
12, then filling When the amount is changed to 400 grams, it is necessary to adjust the circle value to be smaller to a suitable state
.

 　　5.
The power of the screw feeder must be obtained from the filling machine; it is strictly forbidden to directly connect it to other power sources! The screw feeder itself has the functions of automatic feeding, automatic unloading and overload protection; 6.
When the screw feeder automatically feeds and the powder reaches the material level sensor, the feeding machine stops automatically; when the powder is lower than the material level When the sensor is used, the feeding machine will be delayed for 10 seconds before automatic feeding; this function will be cycled during normal production;