Operation guide of automatic ultrasonic cleaning machine

1 Preliminary preparation (1) operators: wear wet proof robes or aprons, round hats, masks, goggles or protective masks, rubber gloves or stab proof latex gloves (2) Preparation: cleaning agent, ultrasonic cleaning machine 2 Operation step (1) check whether there is any foreign matter falling on the bottom of the cavity of the ultrasonic cleaner, if any, it must be removed (2) Prepare cleaning solution: add water to the corresponding scale in the cleaning tank, and prepare cleaning agent according to the instructions (3) Turn on the power switch, and the machine performs self-test (4) Set the temperature of cleaning solution, heat the cleaning solution, and the heating setting temperature shall not exceed 45 ℃ (5) After the equipment to be washed is preliminarily washed under flowing water, the joints of the equipment shall be fully opened, and the detachable equipment shall be separated from each component; the opening of slender and hollow equipment such as straw shall be placed in the special matching cleaning basket of ultrasonic cleaning machine with the inclination downward (6) Then place the basket directly at the bottom of the cavity of the ultrasonic cleaner, and the liquid level of the cleaning solution is 2-4cm higher than that of the instrument, so as to ensure that the cavity is filled with the solution (7) Cover the cover of the ultrasonic cleaning machine, set the cleaning time of 3-5min, and start the ultrasonic cleaning (8) After ultrasonic cleaning, open the cover and take out the instrument (9) Continue the subsequent rinsing, final rinsing and disinfection treatment according to the manual cleaning process 3 Precautions (1) it is forbidden to start the machine when the cleaning solution in the cleaning tank is below the low scale of Zui (2) it is not allowed to place the instrument directly at the bottom of the cleaning tank (3) Cover during cleaning to prevent aerosol generation