Magnetic stirring water bath pot basic operating procedures and maintenance methods

Magnetic stirring water bath pot basic operating procedures: The water bath pot should be placed flat on a fixed platform, the power supply voltage must be consistent with the voltage required by this box, the power socket should use a three-hole safety socket, and the ground wire
must be properly connected before use.

Before the experiment, according to the experimental requirements, add an appropriate amount of water or purified water to the sink to the partition or higher, and then place the experimental vessel on the shelf and cover the hole cover
.

The maintenance method of magnetic stirring water bath pot: 1, if the water temperature in the pot is up to 100 °C, when it is used for boiling water distillation, the adjustment knob can be adjusted to the end
.

2, the use of the need to add an appropriate amount of clean tap water in the pot, you can also add hot water according to the required temperature, to shorten the heating time
.

3, the amount of water in the pot should not be less than one-half, and the heating pipe should not be exposed to the water
.

So as not to burn out, causing water leakage and leakage of electricity
.

4.
When equipped with a digital display header, the counter is ten digits large, and the number is increased by the operation symbol and the subtraction number according to the operation symbol
.

Traffic lights change
with changes in body temperature.

Similarly, the green light is indicative of the heater working and the red light is constant temperature
.

5, do not add too much water, so as not to overflow the water when
boiling.

6.
The effective grounding wire
of the three-eye socket must be used when using.

7.
After the work is completed, put the temperature control knob and the increaser and reducer at a small value to cut off the power supply
.