Learn how to operate a cryogenic pulverizer in a few minutes?

The ultra-low temperature pulverizer is a new type of fourth-generation vibration mill, which adopts the working principle of vibration pulverization, and has newly developed the first domestic touch-screen operating system
.

According to the different characteristics of the material, a number of excellent technologies and the use of high-speed impact force and shear force are used to make the material in the grinding cylinder subjected to the high-acceleration impact, sparring, extrusion, cutting and other effects of the medium, which can be used in a very short time achieve the ideal crushing effect
.

The material is fluidized during the pulverization process, so that each particle has the same stress state, and the effect of precise mixing (dispersion) is achieved while pulverizing
.

By adjusting parameters such as acceleration, it is possible to achieve operations with the purpose of crushing and grinding or precise mixing (mixing) as the main goal
.

The ultra-low temperature pulverizer is used for low-temperature pulverization of heat-sensitive materials and high-toughness materials
.

The machine can be equipped with a liquid nitrogen tank, which is filled with liquid nitrogen into the crushing chamber for low-temperature crushing
.

Ultra-low temperature pulverizer liquid nitrogen cryogenic pulverization can be matched with liquid nitrogen container containing liquid nitrogen pump
.

The safety operation procedures of the ultra-low temperature pulverizer are as follows: 1.
Inspection: Before use, check whether the feet of the pulverizer are all grounded and stable; whether the locking bolts are locked; whether the filter screen of the pulverizer is in good condition; Whether the connection part is tight
.

After confirmation, it can be used only after everything is normal, otherwise it should be repaired or reported
.

2.
Start: (1) Turn on the power supply of the distribution box, the instruction light is on, you can press the button to start the grinder
.

(2) Observe the current and running sound of the pulverizer.
If there is any abnormality, it should be stopped immediately for maintenance
.

3.
Feeding: (1) After confirming the normal operation of the pulverizer, the feeding can be carried out
.

When feeding, pour the material into the hopper first, and use a thin wooden stick to gently push the material into the pulverizer
.

The material should not be too large or too thick
.

(2) Put the crushed fine materials into the transfer bucket.
After the bucket is full, cover the inner and outer lids of the plastic bucket immediately to prevent the material from absorbing moisture
.

(3) If an abnormal sound is heard during the crushing process, it should be stopped immediately for maintenance, and the rear of the Confederate should be excluded from restarting
.

(4) After the feeding is completed, the rotor should be idle for 2-3 minutes, so that all the residual materials are crushed and drawn out before pressing the red button to stop the machine
.

4.
Cleaning: (1) Since the material is easy to absorb moisture, after the crushing is completed, the material on the hopper and the machine body of the crusher should be swept out of the bag immediately with a long brush, and the feeding part of the crusher should be opened.
or water to clean the inside of the grinder
.

 　　(2) It should be re-installed for spare after each cleaning
.

 　　(3) Turn on the heating radiator to ensure that the dryer and grinder are dry before the next use
.