Introduction to the operation process of the automatic ultrasonic bottle washing machine

Introduction to the operation process of the automatic ultrasonic bottle washing machine: 1.
Preparation (1) Check the electrical switch of the equipment, the indication of the instrument, and whether the transmission of the equipment is normal
.

(2) Check whether the pinwheel clutch is in the normal position, and adjust it if it is in the neutral position
.

(3) Turn on the power switch of the machine, turn on the speed control switch, the inverter operation panel screen will display the set frequency, then press the RUN key, the inverter will work, and the motor speed will gradually reach the set value
.

(4) Run the machine empty for 2 minutes first, check whether the equipment and mechanical transmission structure are normal, and whether the running sound is normal, and then start production
.

2.
Turn on the water inlet valve first to fill the liquid storage tank with water, open the non-salt water valve, open the water valve, the spraying is normal, turn on the water pump switch, fill the ultrasonic cleaning tank with water, adjust the water inlet so that the Keep a certain water level in the tank (it is strictly forbidden to open the ultrasonic wave below the water level), and open the air valve
.

When the water level in the tank reaches the specified water level, turn on the ultrasonic switch, and the ultrasonic ultrasonic washing machine enters the bottle washing state
.

(1) The operator puts the vials into the vial tray, turns on the speed control switch, and sets the speed to 10-26Hz (100,400 pcs/min, 7ML), and presses the RUN key to start production
.

(2) When there is a stuck bottle, first press the STOP button to stop, check the stuck bottle, clean up the broken bottle in time, adjust the bottle wheel, and then start the production
.

 　　(3) Dial the vial into the vial wheel and track on the bottle unscrambler turntable, and it is strictly forbidden to pour the vial into it
.