In 2019, environmental protection will strictly investigate these 8 items!

From January 18 to 19, 2019, the 2019 National Ecological Environmental Protection Work Conference was held.
Li Ganjie, Minister of the Ministry of Ecology and Environment, stated that my country will take four years to complete the second round of central ecological environmental protection inspections and "look back.
" Unlike the previous round, this round will not only supervise the provincial (regional, municipal) party committees and governments, but will also supervise the relevant departments of the State Council and central enterprises.
hc360.
com/chem/201901/201901251016205320.
jpg" target="_blank" style="padding: 0px; margin: 0px; font-size: 14px; color: rgb(60, 165, 246); text-decoration-line: none;">The second round of central ecological and environmental protection inspections will explore innovative inspection methods and increase the application of satellite remote sensing, infrared recognition, unmanned aerial vehicles, big data and other technologies.
"The central ecological and environmental protection inspection information system has been established.
After these technologies are applied, It is conducive to improving the efficiency of inspections, especially finding large-scale ecological and environmental issues.
"1.
Looking back on 2018, more than 200 inspection teams, penalized 186,000 cases, and 186,000administrative penalties were implemented nationwide in 2018, with a fine of 15.
28 billion Yuan, a year-on-year increase of 32%, which is 4.
8 times of 2014.
  According to the deployment of the Ministry of Ecology and Environment, all law enforcement personnel holding law enforcement certificates must "bring out and practice.
" Beginning on June 11, 2018, more than 200 inspection teams composed of 3 to 4 law enforcement officers will pull the net in counties (districts, cities) of "2+26" cities in Beijing-Tianjin-Hebei and surrounding areascheck.
  For the "scattered and polluted" enterprises that are not in place, the coal-fired boilers that should be eliminated are not eliminated, the illegal production of pollution control facilities, and the excessive discharge are found to be disclosed together and handed over together, the local government is receiving the handover from the Ministry of Ecology and Environment.
After the checklist is completed, the investigation and investigation of the transfer issues must be completed within the prescribed time limit.
  2.
Typical cases of plastic enterprises investigated and punished 2.
Typical cases   of plastic enterprises investigated and punished   Dongying Donggang Rubber and Plastic Co.
, Ltd.
  Dongying Donggang Rubber and Plastic Co.
, Ltd.
The   People's Court of Kenli District , Dongying City, will be held from 10:00 on January 14, 2019 to March 2019 Public sale activities will be carried out during 10 o'clock on the 15th.
The target of the sale: The target of the sale is the asset portfolio of Dongying Donggang Rubber and Plastic Co.
, Ltd.
, which mainly includes 4 factories, buildings, structures, equipment, land and other assets.
  Appraisal price: 24,309,298.
45 yuan, starting price: 13,613207.
12 yuan, margin: 1,000,000 yuan, price increase: 50,000 yuan.
  Guangzhou Ximan Plastic Products Co.
, Ltd.
  Guangzhou Ximan Plastic Products Co.
, Ltd.
  The People's Court of Panyu District, Guangzhou City will conduct a public sale from 10:00 on December 5, 2018 to 10:00 on February 3, 2019.
  Subject of the sale: A batch of assets and equipment owned by Guangzhou Ximan Plastic Products Co.
, Ltd.
, located at No.
3, Dongsheng Road, Chadong Village, Dalong Street, Panyu District, Guangzhou City (There are two sets of 630KVA transformers in the detailed list listed in the assessment report Due to objections from outsiders, this court has eliminated one set, and only one set is actually auctioned).
  Starting price: 1,151,202 yuan, deposit: 100,000 yuan, price increase: 5,000 yuan and its multiples.
  Laiyang City Dongliang Plastic Woven Packaging Factory   Laiyang City People's Court will conduct public sale activities from 10:00 on November 20, 2018 to 10:00 on November 21, 2018 (except for delays).
Auction subject: Laiyang Dongliang Plastic Woven Packing Factory Mortgage Plant, an unlicensed plant with a construction area of ​​550.
61 square meters.
hc360.
com/chem/201901/201901251016579386.
jpg" target="_blank" style="padding: 0px; margin: 0px; font-size: 14px; color: rgb(60, 165, 246); text-decoration-line: none;">  Appraisal value: 389,424.
95 yuan, starting price: 249,232 yuan, deposit: 20,000 yuan, price increase: 2,000 yuan.
  3.
The second round of environmental protection supervision in 2019: eight items must be checked!   3.
The second round of environmental protection supervision in 2019: eight items must be checked!   1.
On-site inspection   of the ecological environment 1.
On-site inspection of the ecological environment   (1) Special item The action will run through the requirements of the "five-step method" (inspection, assignment, inspection, interview, and special inspection), and through on-site inspection and verification, problems are found and classified and dealt with;   (2) through the implementation of ministerial or provincial-level listing supervision, urging local governments Government rectification is in place   (3) Looking back through the timely organization of inspections on listing supervision issues, ineffective on-site disposal, failure to investigate cases of environmental violations in accordance with the law, or failure to hold relevant responsible personnel accountable in accordance with laws and regulations, interviews and special projects shall be adopted as appropriate Central environmental inspection, accountability and other measures.
  2.
Groundwater Pollution Inspection   2.
Groundwater Pollution Inspection   (1) Whether the site sewage treatment facilities (units) are involved in heavy links, solid waste (hazardous waste) storage sites, chemical storage sites, etc.
, whether anti-leakage and corrosion prevention measures are taken.
  (2) If there is groundwater pollution, whether the treatment measures are in place.
  3.
Sewage pollution control inspection   3.
Sewage pollution control inspection   1.
Water pollution source environmental monitoring   1.
Water pollution source environmental monitoring   The operating status of sewage treatment facilities, historical operation conditions, treatment capacity and treatment water volume, separate management of wastewater, treatment effects, Sludge treatment and disposal.
Whether to establish a wastewater facility operation ledger.
  2.
Monitoring of sewage discharge outlets 2.
Monitoring   of sewage discharge outlets (1) Check whether the location of the sewage discharge outlet meets the requirements;   (2) Check whether the number of sewage discharge outlets of the polluter meets the requirements;    (3) Check whether monitoring sampling points have been set up in accordance with relevant pollutant discharge standards and regulations;   (4) Check whether there is a standardized flow measurement section that is convenient for measuring flow and velocity;   (5) Check whether the total sewage outlet must be set up with environmental protection signs, etc.
;   (6) to check whether the requirements set by online monitoring, monitoring equipment.
  3.
Discharge volume review   3.
Discharge volume review   (1) Operation records of flowmeters and pollution source monitoring equipment;   (2) With water supply devices or with water consumption certificates, the water discharge shall be calculated based on the water consumption;   (3) No metering number and For valid water consumption vouchers, refer to * relevant standards, and estimate the number of water and drainage systems for similar enterprises.
  4.
On-site inspection of noise pollution sources.
4.
On-site inspection   of noise pollution sources.
  Whether pollution control facilities are installed in accordance with the requirements of the environmental assessment documents or environmental assessment approvals, and whether the noise is up to standard.
  V.
Exhaust gas pollution inspection   5.
Exhaust gas pollution inspection   1.
Exhaust gas from boiler, petrochemical, chemical industry, etc.
  (1) Check whether chemical, petrochemical and other enterprises continuously produce combustible organic waste gas for reasonable treatment methods, and adopt recycling or incineration methods Treatment, whether it is reasonable to use incineration, adsorption or combined processes to treat intermittently generated combustible organic waste gas.
  (2) Check the inspection procedures and performance indicators of the boiler combustion equipment, check the operating conditions of the combustion equipment, check the control of sulfur dioxide, and check the control of nitrogen oxides.
  2.
Process waste gas, dust and malodor pollution sources   2.
Process waste gas, dust and malodor pollution sources   (1) Check whether the exhaust gas, dust and malodor emissions meet the requirements of relevant pollutant emission standards;   (2) Check the recycling of combustible gases;  (3) Check environmental protection measures for transportation, loading and unloading, and storage that can emit toxic and harmful gases and dust.
  3.
Air pollution prevention and control facilities   3.
Air pollution prevention and control facilities,   dust removal, desulfurization, out-of-stock, and other gaseous pollutant purification systems.
  4.
Exhaust gas discharge port   4.
Exhaust gas discharge port   (1) Check whether the polluter builds a new exhaust pipe in an area where new exhaust pipes are prohibited;   (2) Check whether the height of the exhaust pipe meets the * or local pollutant emission standards Regulations;   (3) Check whether there are sampling holes and sampling monitoring platforms on the exhaust gas exhaust pipe;  (4) Check whether the exhaust ports are set up according to the required specifications (height, sampling ports, signs, etc.
), and whether the required exhaust gas is in accordance with environmental protection Department installation and practical online monitoring facilities.
  5.
Unorganized emission sources   (1) For emission points where unorganized emission of toxic and harmful gases, dust, and soot, if it is possible to achieve organized emission, check whether the pollutant discharge unit has been rectified and implemented organized emission;   (2) Inspection Dust from coal yards, stock yards, cargoes and during construction production, and whether measures have been taken to prevent and control dust pollution or the installation of dust-proof equipment as required;   (3) Monitor at the company boundary to check whether unorganized emissions comply with relevant environmental protection Standard requirements.
  VI.
On-site inspection   of environmental risks and emergency plans VI.
On-site inspection of environmental risks and emergency plans   (1) Check the compilation, evaluation, and implementation of emergency plans, with text, pictures and related materials of the emergency drill.
  (2) Whether the project meets the environmental protection requirements of the initial rainwater pool (such as chemical industry, electroplating, printing and dyeing, heavy-related industries) and emergency accident pools, etc.
  (3) The situation of emergency supplies reserves (name, quantity, validity period, etc.
).
  7.
On-site inspection of solid* pollution sources  7.
On-site inspection of solid* pollution sources   1.
Inspect the source of   solid*   1.
Inspect the source of solid* (1) Check the type, quantity, physical and chemical properties, and production methods of solid*.
  (2) According to the new "*Danger* List" or GB5085, check the types and quantities of hazards* in production.
  2.
Solid* storage and disposal   2.
Solid* storage and disposal   (1) Check whether the pollutant is in nature reserves, scenic spots, drinking water source protection areas, basic farmland protection areas and other areas that need special protection.
Assume that industrial solids* are centrally stored and disposed of in facilities, places, and domestic waste landfills; Ying Ting believes that this inspection item is more common.
Breeding farms, seriously polluted industrial enterprises, etc.
need to pay attention to this inspection.
  (2) Check whether the solid storage facility or storage site is equipped with facilities that meet environmental protection requirements.
  3.
For dangerous storage, treatment and disposal,   check whether the polluter dumps solids to rivers, hubs, canals, channels, reservoirs and beaches and bank slopes below the *water level, etc.
, where laws and regulations prohibit the dumping of wastes* .
  4.
Solid* transfer   4.
Solid* transfer   (1) Check the status of solid* transfer.
  (2) To check the transfer hazard*, whether to fill in the hazard* transfer form.
And with the approval of the environmental protection department of the local people's government at or above the city level in the place where it is moved out of the district, the environmental protection department of the local people's government at or above the city level in the community where it is accepted.
  (3) Check whether solid waste and hazardous waste signs are installed.
  (4) Check the sludge disposal contract, sludge transportation weighing records, etc.
, to judge whether the sludge production is reasonable.
  8.
The environmental protection department inspects and deals with environmental violations.
  8.
The environmental protection department inspects and deals with environmental violations.
  The need to investigate, transfer, and supervise environmental pollution and ecological damage complaints and reports has attracted great attention.
It's not a simple fine.