-
Categories
-
Pharmaceutical Intermediates
-
Active Pharmaceutical Ingredients
-
Food Additives
- Industrial Coatings
- Agrochemicals
- Dyes and Pigments
- Surfactant
- Flavors and Fragrances
- Chemical Reagents
- Catalyst and Auxiliary
- Natural Products
- Inorganic Chemistry
-
Organic Chemistry
-
Biochemical Engineering
- Analytical Chemistry
-
Cosmetic Ingredient
- Water Treatment Chemical
-
Pharmaceutical Intermediates
Promotion
ECHEMI Mall
Wholesale
Weekly Price
Exhibition
News
-
Trade Service
The simulated transportation vibration table is suitable for the vibration test of toys, electronics, furniture, gifts, ceramics, communications, equipment, computers and automobile and motorcycle parts, etc.
, to inspect their transportation resistance effect or uniform durability
.
The operating procedures are as follows: 1.
Put the required test product in the middle of the workbench
.
2.
Loosen the black torx handle, fix the product to be tested firmly, and then tighten all the screws torx handle
.
3.
Check whether the above equipment collides with other objects (there must be a space of 0.
5 to 1 meter around)
.
4.
Turn the governor knob all the way down
.
5.
Connect the appropriate power supply: 220V/50HZ (at this time, the monitor is powered on, and the whole machine is in standby state)
.
6.
Adjust the relay time according to the product test time
.
7.
After everything is ready, press the start button, turn the knob of the governor, and adjust it to the required speed (general test speed: 100-300 rpm)
.
8.
When the machine runs to the set time, the machine will automatically stop and be in a standby state
.
9.
After the work is completed, turn off the power switch, remove the sample, and record the test data
.
10.
Arrange the machine and fix the guardrail
.
, to inspect their transportation resistance effect or uniform durability
.
The operating procedures are as follows: 1.
Put the required test product in the middle of the workbench
.
2.
Loosen the black torx handle, fix the product to be tested firmly, and then tighten all the screws torx handle
.
3.
Check whether the above equipment collides with other objects (there must be a space of 0.
5 to 1 meter around)
.
4.
Turn the governor knob all the way down
.
5.
Connect the appropriate power supply: 220V/50HZ (at this time, the monitor is powered on, and the whole machine is in standby state)
.
6.
Adjust the relay time according to the product test time
.
7.
After everything is ready, press the start button, turn the knob of the governor, and adjust it to the required speed (general test speed: 100-300 rpm)
.
8.
When the machine runs to the set time, the machine will automatically stop and be in a standby state
.
9.
After the work is completed, turn off the power switch, remove the sample, and record the test data
.
10.
Arrange the machine and fix the guardrail
.
