How to use the high and low temperature experimental chamber

The correct use of high and low temperature experimental chambers and the development of good usage habits can effectively extend the service life of
the equipment.

Next, let's talk to you about how to use the high and low temperature test box and what are its precautions, let's
take a look.

1.
The high and low temperature test box should be placed in a well-ventilated place
.

The back of the experimental box should be more than 60 cm away from the wall, and too much debris should not be placed around
.

2.
The high and low temperature test box should be placed in a place with
low humidity.

3.
The high and low temperature test box should be placed away from heat sources such as radiators, and direct sunlight
should be avoided.

This is conducive to the heat
dissipation of the high and low temperature experimental chamber.

4.
Heavy objects or too much debris should not be placed on the high and low temperature test box, especially other electrical appliances
.

5.
The high and low temperature test box should be placed in a stable place on
the ground.

Otherwise, when the compressor is started, it will vibrate and emit a lot of noise, which will shorten the service life
of the high and low temperature experimental chamber.

6.
When working in the high and low temperature test box, the number of doors should be minimized to reduce the spillover
of hot gas/cold air.

7, the power supply voltage fluctuations, such as repeated power failures, should suspend the use of high and low temperature experimental box, cut off the power supply, to prevent burning out of the compressor
.

After the high and low temperature test box is stopped, do not immediately power on and start the compressor, and should stop for 2-5 minutes before starting
.

Friendly reminder a.
When handling, it should be noted that the fuselage tilt should not exceed 15 °; b.
When handling, it is necessary to maintain the vertical state of the box, do not put it upside down and horizontally, and do not grasp the door handle or drag the condenser to avoid damage
.