How should a Stormer viscometer be maintained and used?

How should a Stormer viscometer be maintained and used? 1.
Take the Stormer viscometer out of the packaging box and place it on the workbench; 2.
Take out the stirring paddle from the packaging box, insert it into the sleeve of the rotating shaft, and fix it with the top tightening screw.
Put it on the flat mouth of the stirring blade; 3.
Plug in the power plug, turn on the power switch at the rear, the system will start self-checking, after the system self-checking is completed, it will enter the standby state, and the display will display "――――"; 4.
Put the test sample into the container that comes with the Stormer viscometer, and the liquid level is about 10mm away from the container mouth; ku value, "gm" means display load value)
.

Press down the lift handle, immerse the stirring paddle into the sample to be tested, the marking line on the stirring paddle shaft is flush with the liquid level, and the Stormer viscometer will automatically start running; 6.
After a few seconds, the display will show the bending tester.
The viscosity value of the sample to be tested can be read at this time
.

(The sample to be tested reaches dynamic equilibrium after being stirred for several seconds.
The data displayed at this time can be considered to be accurate.
Before the data is not displayed, the instrument displays "————") 7.
After the measurement is completed, the roughness meter is finished.
Lift the lift handle to a high position, there is a limit device near the high position, which can keep the instrument in this position all the time
.

The instrument stops rotating and re-enters the standby state; 8.
The instrument has a built-in intelligent display stabilization program, which makes the readings stable for each measurement, which is convenient for the operator to read
.

To measure different units of measure, no need to stop, just switch the selector switch to the position of the unit of measure you need; 9.
There is a hold switch on the instrument panel, turn the hold switch on (down) during measurement to turn The data of the tested sample is locked, and different measurement units can be selected for conversion into the disperser for recording
.

This instrument has a hold memory function.
When the hold switch is turned off (upward), and the previous measurement reading needs to be retrieved, just turn the hold switch on to retrieve it
.

To re-measure, turn the hold switch off
.

 　　Notes for Stormer viscometer: 1.
There are precision measuring parts in the case of Stormer viscometer, and should be handled with care; 2.
Please do not open the instrument shell by yourself, so as not to affect the measurement accuracy of the instrument; 3.
When the Tomer viscometer is not in use temporarily, the lifting handle of the instrument should be kept on the high limit device, and should not be placed in a lower position, otherwise the phenomenon of inflexible lifting may occur; 4.
The company should come to the company regularly every year.
Check the wire rod coater once, or send it to the relevant measurement supervision department for a test
.

 　　The above is the relevant introduction about the use and maintenance of the viscometer.
I believe that everyone has a corresponding understanding of this after reading it.
You can use it as a reference and hope it will be helpful to you
.