Horizontal oscillator temperature setting and maintenance method

1.
The water bath thermostat oscillator places the control switch in the "setting" section, at this time, the temperature displayed on the display is the set temperature, adjust the knob, set to the temperature you need for work
.

(The working temperature you set should be higher than the ambient temperature, at this time the machine begins to heat, the yellow indicator light is on, otherwise the machine does not work) 2, the water bath thermostatic oscillator will control the part of the small switch placed at the "measurement" end, at this time the display shows the temperature for the actual temperature of the air in the test chamber, with the change of temperature in the box, the number displayed will change
accordingly.

3.
When heated to your desired temperature, the heating will automatically stop, and the green indicator light will be on; When the heat in the chamber is dissipated below the temperature you set, a new round of heating begins
.

Horizontal oscillator maintenance method: 1, after each use, immediately clean the instrument
.

2.
After each use, put the water in the water bath pot clean, use a brush to brush off the coarse debris in the water bath pot, and clear the
pot.

Wipe the inside and outside surfaces of the water bath pot with a fine soft cloth and dry
them with a cleaning cloth.

3.
Effect evaluation: The inner surface of the equipment should be free of water droplets, and the outer surface of the equipment should be bright and clean, with no smudges
.

4.
When the water bath pot is in use, it must be reliably grounded, and the water must not overflow into the
control box.

5.
Do not have no water in the water bath pot or the water level is lower than the electric heating pipe to prevent the explosion of
the electric heating pipe.

6.
Carry out maintenance inspection of the instrument once a month and fill in the maintenance record
in time.