High and low temperature test chamber power saving method

Cost saving, to start from the power saving, the following is a introduction to the high and low temperature test box of the five major power saving methods, let's learn it
together.

Power-saving method one: place the position Of the high and low temperature test box should be placed in a cool and ventilated place, avoid direct sunlight, away from heat sources, and when placed, the top left and right sides of the high and low temperature test box and the back should leave appropriate space to facilitate heat
dissipation.

Because the high ambient temperature around the high and low temperature test chamber will increase the power
consumption of the test chamber.

Power saving method two: sealing To often check the sealing of the seal strip of the high and low temperature test chamber, if the seal is deformed, it will affect the degree of tight seam closure, resulting in air conditioning leakage, thereby increasing power
consumption.

If the deformation is serious, it should be repaired and replaced
in time.

Power saving method three: frost after the use of high and low temperature test box for a period of time, will produce some frost, if you can not regularly frost, then it will affect the refrigeration effect, and the power consumption will also increase, and even easy to damage the compressor
.

Therefore, whenever you see that the thickness of the frost exceeds 7cm, you should defrost
it.

Power saving method four: less open the door Every time you open the door once, there will be cold air exposure and hot gas intrusion, so you must run the compressor refrigeration
again.

Therefore, when accessing samples, it is necessary to minimize the number of doors opened and the opening time, open and close the door quickly, and open the door angle as small
as possible.

Power saving method five: often clean To often pay attention to the high and low temperature test box chassis "bath", the surface of the compressor and condenser should be cleaned every two to three months, the more dust, the worse the heat dissipation effect, the greater the power consumption, clean to cut off the power supply, wipe it clean with a damp cloth
.