Glass mosaic tablet press

Glass mosaic tablet press can press different size products Glass mosaic tablet press is a rotary tablet press newly developed and designed by Zui company It is specially used to make glass powder raw materials into various shapes and sizes of mosaic With the continuous change of market demand, glass mosaic tablet press can not only press small mosaic, but also press large mosaic products, such as: 12 * 12mm, 15 * 15mm, 20 * 20MM, 23 * 23mm, 25 * 25MM and other different sizes can be pressed, just change the mold In the production process, the automatic pelletizing machine produced by our company can realize automatic operation The pressed tablets can be pushed directly to the sintering plate through the pelletizing machine, which greatly improves the production efficiency At the same time, the noise is small, the pressure is large, the overpressure stops, avoids the machine damage I before use, the quality of the die shall be checked repeatedly to see if there is any missing edge, crack, deformation, unqualified tightness and whether the device is complete and in good condition 2 Check whether the powder of particle raw material is dry and the powder content Zui in the particle is no more than 10% If it is unqualified, do not use it hard, otherwise it will affect the normal operation of the machine and the service life and the loss of raw material
3 For the first test run, place the indicator pin of pressure regulation control on the "0" position, pour the powder into the hopper, turn the hand wheel of test run by hand, adjust the filling and pressure at the same time, and gradually increase the weight, hardness and softness of the tablet to meet the requirements of the finished product Then, turn on the motor first, and then the clutch for formal operation and production In the production process, the quality of the tablet must be inspected at regular intervals, If it meets the requirements, adjust it if necessary 4 The selection of speed has a direct impact on the service life of the machine Because the nature viscosity of raw materials, the size and pressure of tablet diameter cannot be uniformly specified in use, The structure of the belt pulley can be divided into two ways: fast and slow The long triangle is used to drive the outer rope pulley at a slow speed, which is suitable for pressing minerals, phytochrome and materials that are difficult to form quickly The short triangle is used to drive the inner rope pulley at a fast speed, which is suitable for pressing materials with good adhesion, lubricity and easy to form Therefore, the user must decide according to the actual situation 5 The manager must be familiar with the technical performance, internal structure, operation principle of the control mechanism of the machine and shall not leave the working place during the operation, in order to prevent the machine from being damaged due to failure and ensure the safety of production 6 Pay attention to whether the noise of the machine is normal at any time in use Stop the machine to check and eliminate it in case of sharp noise 2 Lubrication of machine parts 1 Lubrication of general machine parts Oil cups and nozzles are installed on the surface of the machine parts, According to the type of oil cup, grease and oil can be injected respectively Before use, all oil should be added once, and the temperature rise and operation of each bearing can be added halfway 2 The glass oil cup in the middle of the upper cover is the bearing of the lubricating rotary table, which is 3-5 drops per minute during operation 3 Both ends of the transmission shaft are equipped with rolling bearings, and the shaft shell is equipped with oil nozzles, which can be refueled once a week and pressed in with an oil gun 4 The tail of the punch rod and the guide of the curve rail shall be lubricated with butter, and attention shall not be paid to too much, so as to prevent the oil from permeating into the powder and affecting the quality of the tablet 5 Pay attention not to let the oil seep out of the cup, not to let it flow around the machine and on the ground, because the oil is easy to contaminate the material and affect the tablet quality.