Do you know much about the installation steps of the pharmaceutical tablet press?

Pharmaceutical tablet press is research and development or small and large batch production to suppress a variety of granular raw materials into discs, special-shaped tablets are idealized machinery and equipment
.

The exterior design is packaged in stainless steel plates, and the plexiglass panels in the personal studio are fully sealed with a new structure of bright and transparent, eliminating dirt without dead ends
.

The tablet press is small in size, light in weight, clean and tidy, and has the advantages
of complete noise reduction in the dust removal characteristics of the safety alarm system.

Rotation is made of stepless variable frequency variable speed
.

National standard stamping die punching rod
.

The interior of the equipment is made of stainless steel plates for the countertop, which can maintain the gloss of the surface and avoid crossover environmental pollution, which is in line with GMP regulations
.

The side panels can be opened in all directions for easy internal cleaning and maintenance
.

All control boards and actual operating parts are rationally laid out, and industrial touch screen variable frequency variable speed equipment is selected to carry out electrical equipment speed change and reverse reversal
.

Practical operation is convenient, stable rotation and precise
safety.

Implement mechatronics, select touch screen PLC control and actual operation
.

The transmission device is sealed in the car fuel tank under the main body of the pharmaceutical special tablet press, which is a completely isolated separate component, and it is not easy to pollute each other with environmental pollution, easy to exhaust heat and wear, and the equipment is equipped with dust removal equipment, which can digest and absorb the
smoke that inhibits the flying in the room.

Spin loose down punch fixed immovable screw, rotate the handwheel to make the lower punch rod rise to a high part, insert the lower punch rod into the hole of the lower punch rod, pay attention to make the vacancy slope of the lower punch rod point to the downward punch tightening screw and to insert to the end, twist the down punch fixed immovable screw
.

The pharmaceutical special tablet press is equipped with medium mold spinning loose medium mold fixed immovable screws to put the middle mold flat into the hole of the medium mold plywood, and at the same time, the lower punch into the hole of the medium mold is pressed to press the bottom and then tighten the medium mold fixed screw
.

When placing the middle mold, you need to pay attention to putting the middle mold straight in order to prevent the hole edge
from being stuck and destroying when it is placed in.

Install the lower punching screw to insert the upper punching rod into the hole of the upper punching rod to the end, and use the wrench to jam the nut under the punching rod
.

Rotate the handwheel with your hand to slow down the upward punch into the middle die hole to see if there is any impact or friction
.

If there is an impact or friction, loosen the fixed screw of the mold plate, adjust the fixed part of the mold plate so that the upper plate is flushed into the middle mold hole, and then tighten the medium mold plate to fix the fixed screw So that the adjustment finger is not until the upper punch needle enters the middle mold without impact or friction
.