Die installation method of rotary tablet press

Rotary tablet presses are used to press various granular materials into round tablets and special-shaped tablets
.

Its structure is a double-pressure type with feeding equipment and a set of wheels
.

Multiple punching dies can be installed on the turntable, and tablets can be compressed after one rotation
.

The speed of the turntable, the filling of the material, and the thickness of the tablet can be adjusted during tablet pressing.
The mechanical buffer device on the machine can prevent damage to the parts caused by overloading.
The dust generated during the process prevents sticking and clogging and can be recycled into the material for reuse
.

It is the basic equipment suitable for mass production
.

As long as the mold is changed, the rotary tablet press can compress a variety of different tablets, which is also a very scientific method
.

By changing different molds, the thickness and size of the tablet can be changed, which also provides greater protection
.

Therefore, for ordinary people, they rarely touch the tablet press, so how to disassemble and replace the mold is also a very difficult thing
.

So do you know the installation method of this die? Die installation method of rotary tablet press 1.
Loosen the lower punching fixing screw, turn the handwheel to raise the lower punching rod to a higher position, and insert the lower punching rod into the hole of the lower punching rod (please note that The notch of the lower punch rod is aligned with the lower punch and tighten the screw, then insert it into the end) tighten the lower punch set screw
.

2.
Install the lower hole punch, loosen the fixing nut of the upper hole punch, insert the upper hole punch into the hole of the upper hole punch, insert it into the end, and then clamp the lower hexagon of the lower hole punch with a wrench and punch the upper hole.
hole rod and tighten
.

Secure the nut to the upper punch
.

3.
Install the middle die of the rotary tablet press, loosen the fixing screws of the middle die, place the middle die flat in the hole of the plywood of the middle die, and at the same time make the lower punch enter the hole of the middle die, and press it to the bottom , and then tighten it
.

When placing the intermediate mold, be careful to place the flat intermediate mold so that it does not get stuck and damage the hole wall when placed in a curved position
.

 　　4.
Slowly lower the upper punch into the middle die hole and observe whether there is collision or friction
.

In case of collision or friction, loosen the fixing screw of the middle die pressing plate, adjust the fixing position of the middle die pressing plate, make the upper punch enter the hole of the middle die, and then tighten the fixing screw of the die
.

The middle die press plate and then make such an adjustment, which means the installation is qualified until the upper punch enters the middle die without bumping or rubbing
.