Common problems and solutions for humidification devices in xenon lamp aging test chambers

Xenon lamp aging test chamber mainly tests non-standard products, and generally paints
the surface of various solenoid valves.

The surface of the solenoid valve is coated with various solenoid valve surfaces.
Exterior wall panels of automobile oil pipelines, traffic signaling devices, etc
.

This non-standard shape of the product needs to be tested with this test
chamber.

Xenon lamp aging testing machine humidification is mainly the use of humidifiers, so in general, the humidity of the xenon lamp box is unstable, it may be the humidifier problem in the gas test waiting box, the following describes the common problems and solutions
of the humidifier.

1.
The humidifier water tank water is not enough
.

Answer: Add water
.

Remove the steam pipe, lift the tank to disengage from the base, then turn the tank upside down, open the water lid, and add a certain amount of water to the tank
.

After the water injection is completed, tighten the water cap and check the water cap and spring valve
.

(Exit) whether there is a drip
.

Depending on the requirements of the pairing, place the tank on the bottom cover – the tank matches the bottom
.

2.
Poor
steam circuit connection.

Treatment method: the humidifier is placed on the ground behind the right side of the artificial climate box, and then the outlet pipe is inserted into the gas production pipe, and the outlet pipe of the humidifier is maintained at a >3° angle with the inlet pipe of the artificial climate box with a special soft plastic pipe, and the plastic pipe is not sagging or flattened, so as not to block the steam path
by water.

3.
There is a problem
with the circuit connection.

Treatment: Plug the plug into the socket on the right and rear side of the humidifier for use
.

The power supply of the humidifier is controlled by an artificial climate chamber to ensure that it is not wet
.

In addition, if there is a problem with the control system of the xenon lamp aging testing machine, or there is a problem with the humidification pump, this situation needs to contact the manufacturer's technical staff to solve, it is strictly forbidden to remove the test chamber for maintenance without authorization, so as not to cause irreversible damage to the instrument, and at the same time repair itself, there will be some problems
in terms of safety.

Therefore, reporting to the manufacturer for repair is a relatively safe and effective solution
.