An article to understand the main structural characteristics of wet granulator

The wet granulator is completed in the same closed container, dry mixing - wet mixing - granulation, the process is reduced, and it is in line with GMP specifications
.

The entire operation has strict safety protection measures
.

The machine is widely used in pharmaceutical, chemical, food and other industries, and can provide non-standard design products according to customer needs to meet and facilitate the use of users
.

The following editor briefly introduces the main structural features of the wet granulator, as shown below: 1.
Pellet manufacturing device: the rotating drum is horizontally installed under the hopper, and there are bearing supports at the front and rear.
turn around
.

The front bearing seat on the end face is movable.
When assembling and disassembling, as long as three screws are unscrewed, the front bearing seat and the rotating drum can be pulled out in sequence
.

The two ends of the rotating drum adopt symmetrical convex couplings, which are not restricted by inversion and are easy to assemble and disassemble
.

 　　2.
Screen clamp: It is installed on both sides of the rotating drum and is made of steel pipes.
There is a long groove in the middle.
Both ends of the screen are embedded in the groove.
Turn the handwheel to wrap the screen on the outer circle of the rotating drum.
The inner wheel is supported by a thorn wheel, and the tightness can be adjusted
.

 　　3.
Motor for machine base: The motor mounting plate is hinged to the base, and the other end is hinged to the nut.
When turning the handwheel on the base, the adjusting screw rotates, and the nut drives the motor board up and down to adjust the tension of the V-belt
.

 　　4.
The fuselage is an independent cuboid, which consists of three parts: bearing frame, reduction box and machine base
.

The feeding powder hopper is connected with the bearing frame and extends to the outside of the machine.
The front end of the machine base is designed to extend out, and the ground is wide and stable, so it does not need to be installed and can be placed indoors at will
.

 　　5.
Reduction box: It adopts worm gear transmission with a speed ratio of 1:30.
The machine can be stored in the box to ensure that the gear rod, gear and worm gear are well lubricated and noise-free.
The outer end of the worm gear is equipped with an eccentric rod to drive the gear rod to reciprocate.
Movement, the gear shaft meshing with the gear rod makes a reverse rotation movement
.