An article to share the common faults and solutions of several trough mixers

The trough mixer has the characteristics of good dispersion, wide range of use, simple and convenient use, long service life, small investment and quick effect
.

This machine is used to mix powdery or pasty materials, so that different materials can be mixed evenly
.

It is a horizontal trough-shaped single-paddle mixing, and the stirring paddle is a through-shaft type, which is easy to clean
.

The contact parts of the machine and the objects are all made of stainless steel, which has good corrosion resistance, and the mixing tank can automatically turn over and pour the material
.

The following editor briefly introduces several common faults and solutions of trough mixers: 1.
There is leakage in the barrel of the small trough mixer.
This phenomenon is mostly due to its seals, as follows: 1.
Viscous materials When entering the seal, the solution is to clean the seal; 2.
The seal is aging or damaged, and the countermeasure is to replace the seal
.

2.
Difficulty and inability to start when starting.
The reasons for this phenomenon are generally attributed to the following three situations, including three corresponding solutions: 1.
Start operation with full load and overload, the solution: reduce the load, run first and then Feeding; 2.
The power supply is not connected, the phase is missing, countermeasures: ask an electrician to connect the power supply and check the circuit; 3.
The voltage is too low, the countermeasures: avoid the peak power consumption or ensure that the voltage is normal
.

Third, the vibration and abnormal noise of the main machine of the small trough mixer, there are five incentives and five corresponding solutions for this phenomenon: 1.
The paddle shaft is damaged, the countermeasure: replace the paddle shaft; 2.
The installation is not adjusted properly, Countermeasures: Reinstall and adjust the level of the mixer; 3.
Damaged propeller blades, countermeasures: replace the propeller blades; 4.
Damaged transmission, countermeasures: replace damaged parts of the transmission; 5.
No lubricating oil or lubricating pump does not supply oil, Countermeasures: add lubricating oil or replace the oil pump or clear the blockage in the oil pump pipeline
.