-
Categories
-
Pharmaceutical Intermediates
-
Active Pharmaceutical Ingredients
-
Food Additives
- Industrial Coatings
- Agrochemicals
- Dyes and Pigments
- Surfactant
- Flavors and Fragrances
- Chemical Reagents
- Catalyst and Auxiliary
- Natural Products
- Inorganic Chemistry
-
Organic Chemistry
-
Biochemical Engineering
- Analytical Chemistry
-
Cosmetic Ingredient
- Water Treatment Chemical
-
Pharmaceutical Intermediates
Promotion
ECHEMI Mall
Wholesale
Weekly Price
Exhibition
News
-
Trade Service
20 station halobutyl rubber stopper gasket puncture chip drop and puncture force tester One, meet the standard YBB00042005-2015CFDAYBB00332004-2015YBB00322004-2015 two, main parameters: 1, station: 20 (including 10 control bottles), easy to operate, professional independent fixture design 2, PLC control system, independent research and development, innovation, remote control system, free upgrade system 3,7 inch touch screen operation interface, Interface Chinese and English switching, regardless of nationality, wide range of application 4, Chinese and English switching, if you need other text, contact us, 24-hour service 5, dimensions: 500 * 500 * 450; this size is for reference only, to the actual size of the goods prevail 6, piercing speed: 0-100MM / MIN can be set arbitrarily Design value range: 0-200MM / MIN7, test materials: 50ML bottles; 8, puncture force: 0-200N YBB00042005-2015CFDA pharmaceutical packaging material standard puncture chipping] Take 10 of this product, according to the injection with rubber stoppers, gasket puncture chip determination method (YBB00332004-2015) The first method is determined, and the number of chips should not exceed 20.
【Puncture force】 Take 10 of this product, according to the injection with the rubber stopper, gasket puncture force measurement method (YBB00322004-2015) the first method to determine, the average puncture force shall not exceed 75, and the puncture force of each stopper shall not exceed 80N, and there should be no stopper pushed into the
bottle during the puncture process.
Test step determination Method This method is suitable for the determination
of gel cold for injections and gasket puncture chip drops.
Puncture brow drop refers to the number of visible chip drops observed without the help of an amplification tool, measured in terms of the number of fallouts, produced by the puncture test through the rubber stopper or gasket
.
Scope of application of the first method: for injection of suitable specifications of the stopper
.
The purpose of this method is to determine the relative trend relationship between the puncture and chipping of rubber cold or lyophilized rubber plugs for different injections, and the results are affected by a variety of factors, such as the optimization process of the rubber stopper, the type of capping device, the sealing resistance, the size of the puncture, its sharpness, the amount of lubricant on the puncture and the operator's vision
.
Based on the above reasons, in order to obtain comparable results, it is necessary to control the above factors affecting the results, for which the tested rubber stopper must be synchronized with the rubber stopper that knows the number of puncture chips
.
If the results of the known number of puncture chip drops are consistent with the previously known results (i.
e.
the test results are the same as the known number of chip drops or one grain apart), the results measured by the rubber stopper should be judged to be valid
.
Instrumental device injection bottles: more than 50 ml (including 50 ml) and 20 (including control tests)
in support of the test stopper.
Aluminum cover or aluminum-plastic combination cover: matched
with the rubber stopper being tested.
20 pcs
.
Manual capping machine: matched with the rubber stopper under test, one.
Suction filter device
.
