What are the precautions for the operation of powder automatic packaging machine

With the continuous progress of packaging machinery technology, many unnecessary troubles of manual operation are reduced and a lot of time is saved However, the following points should be paid attention to in the operation of automatic powder packaging machine: 1 Before starting the machine, first check whether the operating mechanism of all parts of the machine is in fault, whether the screw is loose, falling off and other phenomena, and check whether the electric control box and external parts are well connected 2 Power on operation, turn on the power switch and turn off the brake switch (turn off the brake key on the function keyboard) 3 Cut the packaging materials into sharp corners after installation, install them into the paper puller through the shaper, rotate the paper puller, and pull them near the conveyor belt At this time, align the cross seal of the heat seal body with the middle position of the color mark of the packaging materials, and then place the cutter on the color mark points 1-2 away from the cross seal of the heat seal body (depending on the length) Note: the cutter should first align the bottom cutter with the color mark and then fix it, then put the ears of the upper blade on the upper and rear part of the bottom blade, and slowly press down the front blade, subject to the ability to cut down the wrapping paper The blade should not be damaged   4 Control and adjust the light spot detection head After the above adjustment, insert the package material into the paper guide of the photoelectric detection head, align the green (red) light spot of the photoelectric detection hair with the upper edge of any color spot above the molding machine, lock the photoelectric detection head, manually move the green (red) color spot of the photoelectric detection hair up and down between the colored spot of the paper package material and the base At this time, the sensitivity indicator light on the back of the photoelectric detection head shall change between the red and green indicators Normally, the red indicator light is on when it is detected on the colored punctuation, and the green indicator light is on when there is no punctuation If there is no such change, the sensitivity knob can be adjusted until the above requirements are met 5 The powder packaging machine adopts stainless steel gongs and rods to measure the blanking form, and the quantitative measurement is adjusted by the step motor and the metering controller.