The operation of the bottle shaker is correct for replacing the thermostatic shaker

Want to know if you are operating correctly to change the thermostatic shaker shaker bottle clamp? Look at the constant temperature shaker, also known as the constant temperature oscillator, is a kind of biochemical instrument that integrates the cultivation and preparation of biological strains, and is a laboratory equipment
for precision culture preparation* in scientific research education and production departments such as biology, plants, microorganisms, environmental protection, genetic viruses, etc.

Constant temperature shaker in the experimental process often appears, when we use the air bath constant temperature culture shaker after a period of time, we now use the culture bottle may be replaced by a larger or smaller culture bottle, at this time, we need to change the incubator fixture of the constant temperature shaker to carry out the next experiment, as a university laboratory microbial cytology experiment commonly used constant temperature oscillation equipment instrument, sometimes, the experimental staff after changing the shaker bottle clamp, and then after the experiment, found, The constant temperature culture shaker will often make a louder noise than before after it is run again, when the laboratory staff often think that the constant temperature shaker has quality problems, in fact, this situation occurs, most of which are caused by
improper operation when the staff replaces the thermostatic shaker shaker bottle clamp.

First of all, when we replace the constant temperature shaker fixture, we need to remove the rocker plate that fixes the thermostatic air bath shaker, and when we remove the rocker plate, we will remove the previous fixture and install the new one, at this time, it should be noted that the arrangement of the thermostatic shaker fixture to be installed on the shaker plate should be balanced, and the front and back should be symmetrical
left and right.

When we install the shaker bottle clamp, we need to fix the shaker plate on the full temperature bath shaker, when fixing the shaker, we need the diagonal fixing method, that is, the two screws of the diagonal are first on the good, and then on the other two diagonal screws, do not start too tight, wait for the 4 corners of the screw to be screwed, we will see again whether the shaker plate is balanced, if it is unbalanced we need to level it, when the shaker adjusts the balance, we will tighten the screws again, fix the rocking plate tightly, This generally does not cause the above problems
.