The centrifugal granulation coating machine has a wide range of adaptability and integrates the performance of the coating pot and the shot blasting machine

Centrifugal granulation coating machine will be powdered or masterbatch added to the centrifugal turntable in the machine, through the action of centrifugal force and friction to form a spiral rope strand-like movement, while the adhesive is atomized by the spray gun and sprayed on the material, so as to condense into tiny particles (starting mother), according to the provisions of the spray atomized adhesive and the powder added to the powder machine in the spiral movement evenly attached to the surface of the particles, layer by layer, while constantly blowing hot air in the ring gap between the turntable and the outer cylinder, so that the pellets are fluidized and dried, so repeated operation, so repeated operation, The diameter of the pellet is gradually increased to form a spherical pellet (granulation)
with true sphericity*.

Centrifugal granulation coating machine maintenance matters: 1.
The lubricating oil in the gearbox and the lubricating grease in the rolling bearing cavity should be replaced
regularly.

2.
If the coating pot is not used for a long time, it should be scrubbed clean, and its surface should be oiled to prevent the oxidation of the copper body of the pot or the production of toxic copper compounds
after moisture.

3.
In order to ensure the lubrication conditions of the worm gear in the gearbox, the temperature rise of the box during operation shall not exceed 50? C
。
4.
The oil-proof sealing ring at the end of the worm shaft should be checked and replaced regularly (generally not more than six months
).

5.
The machine is reliably grounded
.

6.
Do not remove electrical appliances and belt protective covers
.

7.
Each time the liquid is added or the powder is withdrawn, it should be evenly distributed; After each addition of liquid and distribution evenly, it should be fully dried before the solution can be added again, the viscosity of the solution should not be too large, otherwise it is not easy to distribute evenly
.

Advantages of centrifugal granulation coating machine: 1.
Set the performance of coating pot and shot blasting machine in one, wide
adaptability.

2.
The nature of the drugs produced is stable, the remaining materials can be recycled, and the reproduction of the products is good
.

3.
The main engine speed z high reaches 700 rpm, which can make the ball harder and the roundness better
.

4.
Each of the main operating procedures is reasonably adjusted in accordance with the large production process, and the operation is
simpler.

5.
This equipment is combined with production practice to improve, more practical, simpler
operation.

6.
Starting from the mother, enlargement, the material is sprayed in the rotating state, forming the masterbatch, and after spraying the liquid while sprinkling the masterbatch grows, and finally forms pellets, with high
efficiency.