Tell me how to operate the bran pulp filling machine correctly?

The bran pulp filling machine is suitable for small-dose sugar filling and capping processes in pharmaceutical factories.
The components are all made of 316L stainless steel or PTFE, and have the functions of no bottle, no filling, frequency conversion and speed regulation
.

The following editor briefly introduces how to operate the bran pulp filling machine correctly, as shown below: First, before using the syrup filling machine, first open the box to check whether the whole machine is in good condition, whether the electrical components are neat, and whether the line connection is reliable.
and if there is no debris in the hopper
.

In this way, equipment damage and production standstills during plant operation can be avoided
.

Then, turn on the power supply of the filling machine for inspection, and turn on the main power switch of the filling machine
.

After turning on the power, connect the three-phase four-wire 380V, and connect the neutral wire
.

To check that the reducer is turning correctly, the direction marked on the mixer drive chain should be used
.

If it does not fit, replace it at the plug of the power cord
.

 　　Next, press the agitator switch of the syrup filling machine to start and check the drive direction as indicated by the arrow
.

The photoelectric sensor can only be activated when the operating switch is correct
.

After normal operation, the material can be poured into the hopper and then the mixer is started
.

Since the filling machine is a volumetric method, there is a filling process at the very beginning
.

Since larger capacity containers should be placed on the bench before filling begins, users can adjust the desired filling volume after filling
.

During the conditioning process, conditioning should be carried out according to the operating instructions to avoid damage to the equipment or waste of fillers
.

 　　If the filling machine encounters sudden discharge during use, or abnormal phenomena such as bubbles when there is no discharge, it should be shut down immediately, and the work can be continued after finding out the cause of the failure
.

If the material is not discharged, continuous forced operation is prohibited, otherwise it is easy to burn out the motor or its accessories
.