Taber wear gauge test steps and maintenance procedures

Taber wear-resistant instrument is used to test the wear resistance of leather, plastics and other materials, through the way of rotational grinding, the use of different types of friction wheels on the sample rotation friction to detect the wear resistance of materials, is our company Shanghai Qianshi Precision Electromechanical Technology Co.
, Ltd.
independent research and development of test equipment, cost-effective, complete
after-sales service.

Applicable standards: QB/T2726-2005, ASTM D4060, ASTM D1175, D1044, DIN53754, 53799, 53109, 52347, ISO5470, GB/T4085
.

Test steps: Clamping specimens: 1.
Place the cut specimen on the test bench
according to the standard requirements.

2.
Keep the specimen flat, tighten the compression nut and gasket, and tighten the specimen fixing ring
with a hex wrench.

Clamp the wear wheel and weights: 1.
Mount the pre-ground standard wear wheel on the inside of the front of the balance arm and tighten the screw cap
.

2.
Clamp the corresponding weight weights or balance weights according to the
required pressure.

3.
According to the corresponding standards for the wear wheel specifications of different materials tested, install the corresponding specifications of the wear wheel
.

Maintenance procedures: 1.
After each use of the instrument, first close the power supply, remove the test sample on the equipment, and then wipe off the dust and stains on the instrument with a clean dry cotton cloth to completely recover the normal state
before use.

2.
The ambient temperature of the instrument should not be too high, and the relative humidity should not be too large
.

3.
When the instrument is not often used, it should be cleaned once irregularly, and the power is carried out irregularly to avoid causing the line to be damp and bad situations
.