Some common sense of accident handling of automatic labeling machine

The packaging industry has gradually grown, the packaging industry has also entered the formal, labeling machine makes the entire packaging industry more standardized, and automation makes the labeling machine industry more standardized
.
Now the automatic labeling machine is a labeling machine favored by all walks of life, in the application process, how to solve daily small problems, is a lot of users are very necessary to master some small common sense
.
1.
Adjustment of label box: Adjustment of the position of the scratching hook of the standard box: the up, down, left and right scratching hooks are in the same vertical plane and evenly exerted on the label paper, then the label
can be grasped smoothly.
The gap between the label paper and the pressing strip on both sides should be between 0.
8mm ~ 1mm, the gap is too large, causing the label paper to shift in the label box, oblique marks appear, and the gap is too small to cause poor pushing
.
The center line of the label box, the center axis of the label station is tangent to the label paper, the center axis of the label plate is three points into a line, adjust the tangent of the label plate and the label paper (0 distance), and then move the label box closer to 1mm~2mm
.
Adjustment of the label feed roller: When there is no label, the label press plate can be pressed to the very front of the label box and the label is installed, and the label near the label hook finger cannot be crushed
.
2.
Adjustment of the marking station: Adjustment of the rubber roller and the standard plate: the standard plate and the rubber roller are only in contact with each other without any pressure
.
The gap is too large, and there is too much glue on the label board, resulting in glue
dumping.
If the gap is too small and the contact is too tight, the glue will be squeezed out, and there is no glue
on half of the label board.
Adjustment of the scraper and the rubber roller: There can be no gap between the scraper and the rubber roller in the whole length, and if there is a gap, the scraper
can be adjusted by adjusting the eccentric bolt.
Practice has proved that the gap between the standard plate and the rubber roller is between 0.
1mm~0.
2mm is the best
.
This can be achieved by adjusting the bearing housing in the lower part of the roller and, if necessary
, the bearing on the upper part of the roller.
3.
Adjustment of pressure brush device: adjustment of pressure bottle head; The press head should be 20mm
lower when there is no bottle than when there is a bottle.
The overlapping gap of the pressure brush sweeping container is: 10mm~15mm for a single pressure brush and 5mm~10mm
for a combined pressure brush.
The position of the cleaning brush from the sponge is 1mm~2mm
.
The center of the brush is aligned with the label and symmetrical
on both sides.
The brush is perpendicular to the surface of
the container.
4.
Adjustment of the bottle entry star wheel, the bottle out star wheel, and the bottle feeding screw rod: The adjustment of the bottle out star wheel: When the bottle press head is just raised, adjust the star wheel so that the bottle is located in the middle
of the groove of the star wheel.
Adjustment of the bottle feeding screw rod: based on the bottle feeding star wheel, when the bottle is located in the middle of the bottle feeding star wheel groove, adjust the screw rod so that the screw rod feeding side is close to the bottle but does not produce displacement
.
When adjusting the inlet and outlet star wheel and the bottle feeding screw, the bottle press head of the marking machine shall prevail
.
First adjust the bottle feeding star wheel, when the bottle head just overwhelms the bottle, adjust the bottle feed star wheel so that the bottle is in the middle of
the star wheel groove.
Automatic labeling machine makes the product more beautiful, so that the person holding it has more face, because of its own characteristics, automatic labeling machine is more and more loved
by the majority of users.