Single pot 90kg wet granulator

Single pot 90kg wet granulator wet granulator single shift granulation output and quality: 1, theoretical output; 1.
1 The load continuously operates normally for ≥ 4 hours
.

1.
2 A single pot can accommodate a material volume of > 90kg, about 15 pots per day 1.
3 diaphragm pump large grouting speed is not less than 60kg / min 2, to ensure that the diaphragm pump grouting speed can be adjusted 3 wet granulator particle pass rate of more than
97%.

The design of the production line fully takes into account the convenience of material turnover in the production site, and leaves enough maintenance space
.

The wet granulator operates with less than 80 dB
.
noise.

The height of the wet granulator is satisfied by the conventional clean area, such as the height of the special need to be notified
in advance.

The installation of wet granulator has no special requirements on the ground, and if there are special requirements, it is necessary to inform
in advance.

The wet granulator connected to the power supply, air source and water source should meet the requirements of
the workshop.

The device does not have abnormalities such as violent jitter
.

The design is reasonable and does not leave any safety hazards
.

Safe and reliable
during normal operation.

The abnormal situation occurs during the operation of the equipment automatic alarm, and can display the specific fault on the display screen, the whole machine is waterproof
.

The operation interface of the wet granulator is scientific and reasonable, which is easy to operate and clean
.

It is the mainstream method in the current market, and it is necessary to inform in advance if there is any particularity
.

Equipment panel, side plate manufacturing material is 304 stainless steel or above, the surface should be stainless steel matte treatment, the equipment surface should be smooth and smooth, no cleaning blind area, no bumps or scratches and other defects, all corner arc RA≥10mm using not less than 135 ° chamfer excessive
.

The steel parts in direct contact with the material are made of AISI304 stainless steel at least for mirror polishing
.

RA<0.
4 μm
.

Non-metallic parts (seals, etc.
) that come into contact with the material should be made of pharmaceutical grade (or food grade) material, which is not easy to break and does not produce shedding particles after breakage, and is easy to disassemble and assemble
.

Equipment structure, material, cleaning, etc.
must meet the relevant requirements of GMP, low energy consumption, low temperature, to avoid high temperature oxidation, deterioration, melting and loss of materials
.

Material loss shall not be greater than 2%.