Overview of the structure of the benchtop blower drying box

DHG series tabletop blast drying box is a series of products, the volume is 30, 50, 70, 140, 240 liters of five specifications
.

The drying box shell body is painted with steel plate surface, the studio adopts general galvanized steel plate or mirror stainless steel plate, the workshop is equipped with two layers of stainless steel wire shelf, and the middle layer is filled with fine glass wool insulation
.

Double-layer tempered glass is used as an observation window on the door, which can clearly observe the contents
of the box.

The connection between the studio and the door is equipped with a heat-resistant silicone rubber sealing ring to ensure a seal
between the studio and the door.

The drying box power switch, power indicator, damper adjustment knob, thermostat and other operating parts are concentrated in the control panel in front of the box, located on the left front side
of the box.

The heating constant temperature system in the box is mainly composed of an electric motor equipped with a centrifugal impeller, an electric heater, a reasonable air duct structure and a
temperature controller.

When the power supply of the drying chamber is turned on and the fan switch is turned on, the motor runs, directly discharging the heat generated by the electric heater located in the rear of the box through the air duct, and then inhaling the fan through the dry goods in the work room, so that the temperature in the work room is uniform
.

Intelligent temperature controller, with automatic wind speed adjustment function, in the heating process, the motor runs at high speed, the temperature is close to constant time, automatically adjusted to low speed operation, thereby reducing the use of problems
caused by too fast wind speed.

Users can also cancel this function
with a simple operation.

The damper regulator regulates the amount of
air entering and leaving the box by opening the damper adjustment knob.