Operating procedures of Shanghai Shenggang ultrasonic bottle washer

Shanghai Shenggang Ultrasonic Bottle Washing Machine This machine is a cleaning equipment for vials or oral liquid bottles.
It adopts a drum structure.
After the bottle is supplied from the bottle supply tray, the dial wheel sends the bottle, the drum enters the bottle intermittently, and the reuse water is used after passing through the ultrasonic water area.
(or tap water) distilled water and purified compressed air alternately rinse to complete the bottle washing.
This machine has the advantages of stable operation, reliable action and good cleaning effect
.

Comply with GMP requirements
.

The operating procedures of the ultrasonic bottle washing machine mainly include the following points: 1.
Preparation (1) Check the electrical switch of the equipment, the indication of the instrument, and whether the transmission of the equipment is normal
.

(2) Check whether the pinwheel clutch is in the normal position, and adjust it if it is in the neutral position
.

(3) Turn on the power switch of the machine, turn on the speed control switch, the inverter operation panel screen will display the set frequency, then press the RUN key, the inverter will work, and the motor speed will gradually reach the set value
.

Stop pressing the STOP key
.

(4) Run the machine empty for 2 minutes, check whether the equipment and mechanical transmission structure are normal, and whether the running sound is normal, and then start production
.

2.
Turn on the water inlet valve first, fill the liquid storage tank with water, open the non-salt water valve, open the water for injection valve, the spraying is normal, turn on the water pump switch, fill the ultrasonic cleaning tank with water, adjust the water inlet to make Keep a certain water level in the tank (it is strictly forbidden to open the ultrasonic wave below the water level), and open the air valve
.

When the water level in the tank reaches the specified water level, turn on the ultrasonic switch, and the ultrasonic cleaner enters the bottle washing state
.

(1) The operator loads the vials into the vial tray, turns on the speed control switch, sets the speed to 10~26Hz (100~400pcs/min 7ML), and presses the RUN key to start production
.

 　　(2) When there is a stuck bottle, first press the STOP button to stop, check the stuck bottle, clean up the broken bottle in time, adjust the bottle wheel, and then start the production
.

 　　(3) Dial the vial into the vial wheel and track on the bottle unscrambler turntable, and it is strictly forbidden to pour the vial into it
.

 　　3.
Note (1) After the production is over, the ultrasonic wave must be turned off first, and then the water is released
.

 　　(2) To adjust the production volume, please set the required operating frequency according to the inverter manual
.

 　　(3) If the ultrasonic wave does not work, please ask professional maintenance personnel to overhaul
.

 　　(4) It is strictly forbidden to pour the bottle into the track
.

 　　(5) It is strictly forbidden to turn on the ultrasonic wave below the water level
.