Mold incubator MJ-I series box structure and working principle

MJ series mold incubator is composed
of five main parts: box, temperature control system, high and low temperature conversion system, gas circulation system and lighting system.

Box: There is a studio, box shell, box door and so on
.

The shell of the box is sprayed with steel plate surface, and the box door is equipped with a large area of double-glazed observation window, which is colorful and beautiful; The studio is made of mirrored stainless steel, and the four corners of the semi-circular arc are easy to clean; The height level of the shelves made of stainless steel wire in the interior is adjustable; Polyurethane foam board between the shell and the studio is filled as a thermal insulation layer to ensure the temperature in the studio; The joint between the studio and the door is equipped with a magnetic sealing ring to ensure the sealing and thermal insulation of
the studio.

Temperature control system: temperature controller, temperature sensor, temperature protection system and other components
.

The temperature controller is equipped with a deviation alarm function, and the user can adjust the deviation alarm parameters according to the needs of self-setting; If the temperature protection function of the instrument fails, the overheating protector is automatically disconnected when the temperature in the working room reaches about 70 ° C to avoid dangerous situations
.

High and low temperature conversion system: there is a heating system, refrigeration system
.

The heater and evaporator are placed at the rear of the studio, their working state is controlled by the temperature control system, and the gas circulation system sends the cold and heat to the studio, so that the temperature of the studio reaches uniform and stable
.

Gas circulation system: there are high-speed circulation fans, air ducts and other components
.

It can ensure that the air in the studio is fully circulated, so that the temperature of the studio is uniform and stable
.

Lighting system: there are switches, 8W ultraviolet tubes, electronic ballasts and so on
.

Easy to operate, easy to access items and observation
of experimental products.