-
Categories
-
Pharmaceutical Intermediates
-
Active Pharmaceutical Ingredients
-
Food Additives
- Industrial Coatings
- Agrochemicals
- Dyes and Pigments
- Surfactant
- Flavors and Fragrances
- Chemical Reagents
- Catalyst and Auxiliary
- Natural Products
- Inorganic Chemistry
-
Organic Chemistry
-
Biochemical Engineering
- Analytical Chemistry
-
Cosmetic Ingredient
- Water Treatment Chemical
-
Pharmaceutical Intermediates
Promotion
ECHEMI Mall
Wholesale
Weekly Price
Exhibition
News
-
Trade Service
Mold incubator maintenance methods and precautions (1) The mold incubator should be managed by a special perso.
Once any switches and adjustment knobs on the operation panel are fixed, do not twist them at will, so as not to affect the temperature, CO2, and humidity fluctuations in the box , while reducing the sensitivity of the machin.
(2) If carbon dioxide is not used for a long time, the CO2 switch should be turned off to prevent the CO2 regulator from malfunctionin.
(3) The CO2 used must be pure, otherwise the sensitivity of the CO2 sensor will be reduced and the CO2 filter device will be pollute.
(4) In an incubator without humidity control, in order to maintain the stability of CO2 in the box, a container containing water should be placed at the bottom of the bo.
There is also a three-gas incubator, which is a new product further improved on the basis of the carbon dioxide incubato.
The principle is the same as that of other incubator.
The characteristic is that not only CO2, but also nitrogen and oxygen can be added, and the content of various gases is controlled and adjusted by compute.
Mainly used for the reproduction and cultivation of some special microorganism.
(5) The added water must be distilled water or non-ionized water to prevent minerals from accumulating in the water tank and causing corrosio.
It must be replaced every yea.
Once any switches and adjustment knobs on the operation panel are fixed, do not twist them at will, so as not to affect the temperature, CO2, and humidity fluctuations in the box , while reducing the sensitivity of the machin.
(2) If carbon dioxide is not used for a long time, the CO2 switch should be turned off to prevent the CO2 regulator from malfunctionin.
(3) The CO2 used must be pure, otherwise the sensitivity of the CO2 sensor will be reduced and the CO2 filter device will be pollute.
(4) In an incubator without humidity control, in order to maintain the stability of CO2 in the box, a container containing water should be placed at the bottom of the bo.
There is also a three-gas incubator, which is a new product further improved on the basis of the carbon dioxide incubato.
The principle is the same as that of other incubator.
The characteristic is that not only CO2, but also nitrogen and oxygen can be added, and the content of various gases is controlled and adjusted by compute.
Mainly used for the reproduction and cultivation of some special microorganism.
(5) The added water must be distilled water or non-ionized water to prevent minerals from accumulating in the water tank and causing corrosio.
It must be replaced every yea.
