Installation and commissioning of walk-in high and low temperature alternating laboratories

Walk-in high and low temperature test chambers are a very important large test equipment relative to many industries, and usually can quickly detect the performance
of products.

However, these are to ensure that the walk-in high and low temperature test room installation and commissioning is correct in the case of play, Liuqin Technology to talk about what need to be paid attention to when installing the walk-in high and low temperature test chamber? 1.
First, the walk-in high and low temperature test room must be spaced out of more than 50cm space around the wall or equipment, so as to facilitate subsequent maintenance
.

2, in order to ensure that the use of the process can be stable to play the function and performance of the equipment, we should install the equipment in the perennial temperature of 15 ~ 25 °C, relative humidity less than 85% of the place, if the installation site does not have this condition, then you can install air conditioning or exhaust fan to achieve the purpose
.

3, can not be installed in the test equipment with high temperature heating source place, it is best to near the temperature should not have a sharp temperature change
.

4.
Before installing the walk-in high and low temperature test room, we must use the spirit level to determine whether the ground is level
.

5.
Ensure that the trial equipment is installed in a place
without direct sunlight.

6.
Before installation, it is necessary to determine whether the ventilation of the place is good
.

7.
Can be installed in a place
close to the power supply.

Whenever possible, install the walk-in high and low temperature test chamber close to the power supply
.

The installation of the walk-in high and low temperature test chamber is a very important step, if the equipment is not installed, it will cause more serious trouble
to the subsequent test.