In-depth analysis of the technical principles of the lower angle crusher

Angle cutting crusher can fully meet the needs of users for material crushing, depolymerization, pre-treatment, shape and other aspects, and is widely used in pharmaceutical, food, chemical, agricultural, environmental protection, plastics and other industries
.

Technical principle of angle crusher: This series of models is a device
that uses the interaction of moving knife and fixed knife to crush materials into granular forms by cutting, impact, extrusion and other ways.

It consists of an inlet port, a crushing chamber, a gathering box, etc
.

The material enters the crushing chamber from the feeding port, is crushed by the high-speed rotating moving knife and the fixed knife, and then sorts through the screen, falls into the gathering box to complete the crushing
.

Performance characteristics of angle crusher: (1) strong crushing capacity, wide range of applicable materials, because the machine matches the motor with strong performance, it has good crushing capacity for materials with high hardness, high toughness and high fiber; The breaker set is made of high-grade carbon steel and has good adaptability
to various materials.

(2) Good handling performance, material particle size can be freely selected
through the screen.

(3) good stability, low noise, no vibration, no need to fix, the base is installed with four castors, can be moved arbitrarily, the use of very convenient angle crusher operation method: 1.
Preparation before the use of the crusher: check whether the connecting bolts are loose, whether there is chips in the crushing chamber, whether the lubricant of the rotating bearings and other rotating parts is sufficient, whether the belt of the transmission device is uniform The motor is disconnected, the starting phenomenon, whether the junction box and the grounding device of the motor are firmly connected, Ensure that the protective devices of the drive mechanism are intact and check before starting the machine.
After inspection, make sure that all parts of the machine are in good condition before starting work.
2, the crusher on time maintenance work: regularly check the tightening of the bolted connection points of each component, and tighten and loosen the bolts in time; Clean the sieves in the studio after each job to drain excess material and blockages; Regularly check the wear degree of the fragile parts of the machine, replace the wear parts in time, ensure that the feed is uniform, do not too much or too little, and prevent the machine from running at excessive speed.
Load operation phenomenon; The lubricating oil should also be kept clean and the bearings should be cleaned regularly to ensure bearing flexibility.