Detailed instructions for use of intelligent air/cargo shower room

Detailed instructions for use of the intelligent air/cargo shower room The work is normal.
At this time, the air/cargo shower room is in the initial state, and personnel can operate normally.
Note: it must be grounded.
2.
Door entry procedures: (1) When the personnel entering the clean area open the outer door, the inner door electric lock will automatically lock In order to prevent the unpurified air in the air shower from flowing into the clean area, the lighting in the air shower is turned
on.

(2) After entering the air shower and closing the outer door, the voice prompt: "Hello, please stand in the induction area"
.

The infrared probe of the system starts to detect whether there is a person, and if it is detected, the system switches to the air shower process
.

(3) The inner and outer doors are locked before the air shower, the fan starts to air shower at high speed, and at the same time, the air shower countdown starts to count
.

(4) If the system cannot detect anyone in the air shower within the specified time after the outer door is closed, the system will automatically unlock the inner and outer doors and return to the standby state, and the infrared will continue to detect.
If someone is detected, the inner and outer doors will be locked, and the air shower will start.
wind shower
.

(5) During the air shower, someone pressed the up, down, and lighting switches
.

 　　(6) During the air shower, the air shower will end when someone presses the emergency stop switch
.

Press the emergency stop button again to cancel the emergency stop state
.

 　　(7) After the air shower is over, the inner door is unlocked
.

 　　(8) After the person walks out of the air shower room and closes the inner door, the air shower starts at a low wind speed, stops after 10 seconds, returns to the original state, and waits for the next use
.

 　　(9) If the air shower is completed, after the inner door is unlocked
.

If the person inside did not leave the air shower within the specified time, the system defaults that the person may have left and automatically returns to the standby state
.

 　　(10) After the light is on, it will automatically turn off if it is not triggered again within the specified time
.

 　　3.
Procedure for going out: (1) Open the inner door, the electric lock of the outer door is self-locking, and the lighting of the air shower room is
lit.

 　　(2) When a person walks into the air shower and closes the inner door, the system starts to detect whether someone is in the air shower.
If no one is detected within the specified time, the inner and outer doors will be unlocked
.

 　　(3) If someone is detected, when the system waits for the person to open the outer door, the inner door is locked, and when the outer door is closed, the system returns to the initial state
.

 　　(4) In case of special circumstances, personnel can choose to return to the clean area.
The system waits for personnel to open the inner door, and the outer door is powered on and self-locks.
When the inner door is closed, the system returns to the initial state
.

 　　(5) After the outer door is opened, if no one is detected within the specified time, if the outer door is opened first, the system will enter the process of entering the clean area; if the inner door is opened first, the system will enter the process of leaving the clean area
.

 　　(6) After the light is on, it will automatically go out if it is not triggered again within the specified time
.